Special Instructions - Whittier Wood Furniture 677Wb Instrucciones Para Armar

677Wb Kid's Table — Parts List
Please identify the parts and check that quantities received match what is on this list.
Cb - Top Assembly - Qty. 1
1. Lay the Top Assembly (Cb) face down on a clean protected surface. Place each Leg (D) between the aprons so the
hole in the corner of the leg faces the Leg Bracket (Eb). See Figure 1. Insert a 3/8" x 2-1/2" Hex Bolt (F) with
a Washer (B) through the leg bracket and into the Insert Nut (G). Securely fasten. See Figure 1a.
2. Turn the table upright.

Special Instructions

I f a top or panel becomes cupped, do not be alarmed. The panel was flat when it was
manufactured. It is a natural characteristic of wood in an unfi nished state to cup
from uneven moisture conditions. The fi gure at the right shows an exaggerated
view of what could happen. This only means that the convex side has
absorbed moisture, or the concave side has dried out.
Usually a cupped panel will equalize and straighten out if both sides are
exposed to similar conditions for a day or so.
Page 2 677Wb
— — 09/10
If you need to replace a part, refer to the following letter and item name.
D - Leg - Qty. 4
B - Washer - Qty. 4
Assembly Instructions
Tools Required: 1/2" or Adjustable Wrench
G
Fig. 1a
Fig. 1
Eb - Leg Bracket
- Qty. 4 (attached)
F - 3/8" x 2-1/2" Hex Bolt
- Qty. 4
Eb
B
F
Cb
G - Insert Nut
- Qty. 4 (inserted)
H - #8x1-1/4" Pan Head
Screw - Qty. 28 (inserted)
D
B
F
Apron