4. Should the package contents be incomplete or damages
be found, do not take the appliance into operation. Take
it immediately back to the dealer.
NOTE:
Dust or production residues can be located on the appli-
ance. We recommend to clean the appliance as described
under "Cleaning".
Scope of Delivery
1 × air cooler
4 × castors
8 × screws
2 × freezer packs
1 × remote control with button cell type CR2025
Overview of the Components
1 Ventilation grille
2 Control panel
3 IR receiver for remote
4 Air intake filter with internal honeycomb filter
5 Water tank
6 Castors
7 Water tank lock
8 Roller locking brake
Control Panel
9 COOLER button (Air humidifier)
10 SWING button (Oscillation)
11 TIMER button (Time-delayed switch-off)
12 Display
13 WIND button (Wind change functions)
14 SPEED button (Speed level)
15 WiFi button
16 ON / OFF button (Switching the appliance on / off)
Roller Assembly
1. Place a covering, such as a blanket or something similar,
on the floor and lay the basic appliance on its back.
2. Using 2 screws for each, fasten the rollers to the bottom
of the appliance. Use a Phillips-tip screwdriver to do this.
3. Set the appliance upright once again.
Remote Control
NOTE:
The button cell in the battery compartment of the remote
control has been secured with a foil for transport. This
will extend the durability of the battery. Before initial use
please remove this foil so that the remote control is ready
for operation.
The range of the remote control is limited.
48
PC-LK3088_IM
When using the remote control, please ensure that there
are no obstacles placed between it and the sensor on the
appliance.
Changing the Battery of the Remote Control
If the range of the remote control is reduced during use,
please proceed as follows:
1. Open the battery compartment on the bottom of the
remote control by holding the lever inwards and pulling
out the battery compartment.
2. Replace the button cell with a battery of the same type
(CR2025). Ensure correct polarity.
3. Then close the battery lid.
Notes for Use
Location
• A suitable location is a non-slip, even surface.
• Press the roller locking brake downward.
• Do not place the appliance onto wood, to avoid deforma-
tion due to moisture.
• Watch out for electrical devices close by. They must not
get wet.
• Keep a distance of 2 meters from electrical equipment
and delicate furniture to protect these from moisture.
• The appliance works more effectively if you have the
windows and doors closed during operation.
NOTE:
Do not forget to air on a regular basis.
Water
• Only use distilled or boiled, cold tap water without
additives.
CAUTION:
Do not fill the water tank with water from clothes
dryers and water with additives (such as scented oils,
perfume, softeners, or other chemicals). Doing so may
damage the appliance.
• Replace the water every 3 days, even if it has not yet
been used.
• Remove the water from the water tank if the appliance is
out of use for long periods.
Fill with Water
1. Open the lock of the water tank located on the rear.
panel. For unlocking, turn it counter-clockwise.
2. Pull the water tank out a little
3. Hold the water tank firmly with one hand. Fill the water
tank. Pay attention to the MIN and MAX labels while
doing this.
4. Slide the water tank back into the appliance.
5. Close the lock by turning it clockwise.
24.11.20