Fine Filter; Protect Against Freezing - Crosley XD Serie Manual Del Propietário

Care and cleaning
Filters
Inspect and clean the filters periodically . This should be done every other month or more depending on usage . If
there is a decrease in wash performance or dishes feel gritty, this is also an indication the filters need to be cleaned .
The retaining posts can be a
WARNING
choke hazard for small children if
removed from the dishwasher. Keep out of reach
of children.
Ultra-Fine Filter
To clean the Ultra-Fine Filter, remove the bottom rack .
Twist the Ultra-Fine Filter counterclockwise and lift to
remove . Rinse filter with warm soapy water and use
a sponge to carefully remove any stubborn particles .
Scrubbing with scouring pads or brushes can damage
the filter . Once cleaned, replace the Ultra-Fine Filter, and
twist it clockwise to lock in place .

Protect Against Freezing

If your dishwasher is left in an unheated place during the
winter, ask a service technician to:
1
Turn off electrical power to the dishwasher . Remove
fuses or trip circuit breaker .
2 Turn off the water supply and disconnect the water inlet
line from the water valve .
Does Your Dishwasher Have an Air Gap?
An air gap protects your dishwasher
against water backing up into it if a drain
clogs . The air gap is not a part of the
dishwasher . It is not covered by your
warranty . Not all plumbing codes require
air gaps, so you may not have one .
49-4000102 Rev 4

Fine Filter

To clean the Fine Filter (mesh plate), remove the bottom
rack . Remove the Ultra-Fine Filter .
Twist each of the two retaining posts located toward the
back bottom of the tub counterclockwise, and remove the
Fine Filter . Rinse filter with warm soapy water . Scouring
pads or brushes can scratch the filter surface but a soft
brush or sponge may be needed to remove stubborn
soils or calcium deposits caused by hard water . Once
cleaned, replace the Fine Filter and the Ultra-Fine Filter .
Twist the two retaining posts clockwise to lock in place .
3
Drain water from the water inlet line and water valve .
(Use a pan to catch the water .)
4 Reconnect the water inlet line to the water valve .
The air gap is easy to clean.
Air gap 1
Turn off the dishwasher and lift off the air gap cover .
2
Remove the plastic cap under the cover and clean with a
toothpick .
Check the air gap any
time your dishwasher
3 Replace the cap and cover when the air gap is clean .
isn't draining well .
Retaining
Posts
Fine Ultra-Fine
Filter Filter
Spray
Arm
13