Tabla de contenido
Publicidad
ADJUSTMENTS
1. Slide the Mat Guide to the right until it contacts the Locator Pin
(A) in the 2" (50mm) hole, and tighten the Lower (B), then Upper
Locking Knobs on the Mat Guide. See Figure 17.
2. Place an 8" x 10" matboard under the Clamp in full contact with
the Mat Guide at the lower part of the Mat Guide.
3. Make a bevel cut about 1" (25 mm) long near the lower edge of
the mat. Move the mat to the top of the Mat Guide and make
another cut starting beyond the first cut and running into it. When
the Mat Guide is properly squared, these two cuts will coincide
and appear to be a single cut.
4. If the two cuts are not in line, the Mat Guide must be squared as
follows: Loosen the left-hand (C) and right-hand (D) screws on the
Mat Guide Slide (E). Loosen both the Lower Locking Knob (B) and Upper Locking Knobs (F). Place the two
Squaring Fixtures (G) (from the parts bag) on the steel Shaft, one near the bottom end of the Mat Guide and the
G
Figure 18
5. Always tighten the Lower Mat Guide Locking Knob (B) before the Upper Locking Knob (F). It is the lower one
which aligns the Mat Guide. The upper one simply anchors the upper end of the Mat Guide.
6. Make a bevel cut and measure its distance from the left side of the mat. If it is not exactly 2" (50mm), turn the hex
screw (H) clockwise to decrease or counterclockwise to increase the mat border. Then, re-position the Index (J) to
read 2" (50mm) on the scale.
K
Figure 19
2. Adjust set screw (L) in the same manner. Be sure to slide the Cutting Head
while tightening the set screw so you do not over-tighten and cause damage.
SQUARE THE MAT GUIDE
F
G
CUTTING HEAD ADJUSTMENTS
1. Periodically adjust the Cutting Head to assure a
close fit on the Shaft. Slowly tighten either of the
set screws (K) while sliding the Cutting Head back
and forth on the Shaft. When you feel a drag,
loosen the screw until the Cutting Head slides
freely. Repeat with the other set screw (K).
C
E
other near the top, as in Figure 18. Remove the
Locator Pin (A) and use your left hand to slide
the Mat Guide firmly against both Squaring
Fixtures. While keeping pressure against the
Squaring Fixtures tighten the Lower Locking
Knob (B) then the left hand screw (C), followed
by the right hand screw (D) on the Mat Guide
Slide (E). Be sure to leave the Upper Locking
Knob (F) loose during this adjustment. Retest
for squareness as in item 3 above.
12
J
D
A
B
Figure 17
H
L
Figure 20
MyBinding.com
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920
D
Publicidad
Tabla de contenido
