Assemble, making sure
top edges are flush.
Channel
Door
Panel
Bottom Seal
6. Assemble the Door
Align the slotted holes on the hinge with the channel in the door panel. Make sure the top edge of
the hinge assembly is flush with the top of the channel.
Install the hinge jamb cap on the top of the hinge jamb where it aligns with the edge of door.
Secure the hinge to the door panel using four #8-18 x 3/8" panhead screws (provided).
Starting on the hinge side of the glass, press the bottom seal onto the bottom of the door panel.
NOTE: Leave a small gap at the handle side of the door for clearance from the strike jamb. The door will
not close properly without this gap.
1036565-2-B
Hinge
Jam Cap
Hinge
Assembly
#8-18 x 3/8"
Panhead Screw
Hinge
Jam Cap
8
Top View
Channel
Door Panel Extrusion
Bottom View
Hinge Jamb Cap
Kohler Co.