Assembly And Installation - Ritter SES 10 Instrucciones De Uso Y De Montaje

English
ASSEMBLY AND
INSTALLATION
Please refer to the illustrations
provided at the front and back of
these instructions.
For more information about
installation, see also
www.ritterwerk.de/
installation-notes or the QR code
on the cover.
Safety instructions
To avoid personal injury or
damage to the appliance, please
observe the following safety
instructions:
– Assembly must be performed
by qualified personnel only.
ritterwerk will not be held
liable for the consequences
of improper or incorrect
assembly.
– The power cord must be
routed in such a way that the
appliance can be fully inserted
without pinching it. The power
cord must be routed directly
and without obstruction from
the built-in system to the
socket to be installed in the
floor cabinet.
– Unplug the power plug from
the socket before assembly.
10
Installation conditions
Appliance dimensions:
– Width of appliance cover plate:
365 mm
Appliance width: 342 mm
– Appliance height: 103 mm
The following dimensions repre-
sent minimum values:
– Clearance width: 365 mm
– Clearance height: 105 mm
– Required depth: 460 mm
Mounting the socket
Note:
A surface-mounted socket (that
complies with VDE/DIN 49440,
ÖVE, SEV) must be mounted
either on or behind the rear
panel at the height of the built-in
vacuum cleaner.
It must be possible to slide the
vacuum cleaner in fully when the
power plug is plugged in.
The power plug must be eas-
ily accessible to the user to
ensure that the appliance can
be unplugged from the mains as
required (for example, prior to
cleaning).
Installing the vacuum cleaner
Mark the slot to be cut out on
the skirting board.
Cut out the slot using a saw.
Paint the inner edges of the
skirting board with a water-resist-
ant varnish.
Insert the power plug into the
socket and slide the vacuum
cleaner into the slot.
Note:
All dimensions in the assembly
drawings stated in mm!