Basic Operation; Advanced Operation - Xtech VIBRANT XTH-705 Manual Del Usuario

III. Basic operation
Charge your earphones
• Plug the supplied charging cable into the USB port of your computer or to
a 5VDC USB adapter to charge the battery.
• Connect the micro-USB end of the cable into the micro-USB port of the
control capsule.
• The charging indicator light will turn ON red, and the LED will turn solid
blue once it is fully charged.
• The earphones battery should be initially charged for at least 3 hours.
Thereafter, the battery will take around 2 hours to recharge.
• Turn off the earphones when not in use to conserve battery life.
• Make sure that your earphones are fully charged before using it for the first
time.
Turning your earphones on and off
1. Press and hold the Power/multifunction button for 3-5 seconds to turn
on the earphones. The LED will turn ON and alternate between red and
blue.
2. To power off the device, press and hold the power button again for 3-5
seconds. The LED will turn OFF.
IV. Advanced operation
Note: Before installing this product, please make sure that your device is
compatible with Bluetooth .
®
Pairing the earphones with your mobile device
1. Place the earphones and the mobile device not more than one meter
away from each other.
2. Set your mobile device to "discover" the wireless earphones.
3. Press and hold the power button for several seconds to turn the
earphones on. The Light indicator will flash red/blue indicating that the
earphones are in pairing mode.
4. An audible tone will be heard to indicate that the earphones have
entered into the pairing mode.
5. On your mobile phone, the newly discovered audio device will be
displayed in the Bluetooth list.
®
6. Next, tap on XTH-705 to start the pairing process with your mobile
device.
7. If you have a lower Bluetooth version, you may be prompted to enter
®
the passkey 0000 (4 zeros).