Manuales relacionados para Truper DES-550
Resumen de contenidos para Truper DES-550
- Página 1 Manual Electric string trimmer/edger 550 W Power DES-550 Applies for: Code Model 101263 DES-550 Read this manual thoroughly CAUTION before using the tool.
-
Página 2: Tabla De Contenido
Manual before Parts using the tool. Assembly Keep this manual for future references. Start Up The illustrations in this manual are for reference Maintenance only. They might be different from the real tool. Troubleshooting Authorized Service Centers Warranty Policy DES-550 ENGLISH... -
Página 3: Technical Data
Technical Data DES-550 Code 101263 Description Electric string trimmer/edger Voltage 127 V Frequency 60 Hz Current 4.3 A Power 550 W Speed 10 000 RPM Cutting capacity 13” Cutting string diameter 1.6 mm Duty cycle 50 minutes work per 20 minutes idle. Maximum six hours daily. -
Página 4: General Power Tool Safety Warnings
General Power Tool Safety Warnings WARNING! Read carefully all safety warnings and instructions listed below. Failure to comply with any of these warnings may result in electric shock, fire and / or severe damage. Save all warnings and instructions for future references. -
Página 5: Safety Warnings For String Trimmers
• Use only the original nylon string and for no reason at all replace it with metal string. • For best results it is recommended to use only original thread replacements such as: HTA-65B, HIDE-65P,HTA-65 and HDU-15-65 Truper brand. ® ENGLISH... -
Página 6: Parts
Parts Switch Handle trigger Switch Lock Power cord fastener Extension Cord Output Auxiliary handle Telescopic Shaft Adjusting Knob Telescopic Shaft Security alert tag Trimmer head Safety alert. Retractable stop Read the operator’s manual before using the tool. Wear ear protectors. Head angle Edger adjustment pedal... -
Página 7: Assembly
Assembly Guard Adjust the Telescopic Shaft • To assemble and disassemble the guard tighten or • Disconnect the Trimmer. Unscrew the adjusting loosen the four screws (A) in the bottom of the guard. knob (A) turning into the open lock direction( ). CAUTION •... -
Página 8: Start Up
Assembly Cutting string spool • The trimmer shall be off and disconnected. Remove the spool-retaining cap (B) pressing towards the side tabs. Pull the cap upward. • Remove the empty spool. Double check is clean and has no damaged or worn parts. •... - Página 9 Start up Operation CAUTION • Remember that the trimmer users are responsible of their safety as well as the safety of people near the work area. Follow all the safety standards (pages 4 and 5) before, during and after operating the tool. •...
-
Página 10: Maintenance
Maintenance Cleaning Carbon brush replacement • Cleaning after each use will keep the trimmer in the • Carbon brushes should be checked periodically. best of working conditions and will lengthen its useful • When one or both carbon brushes show signs of wear life. -
Página 11: Authorized Service Centers
In the event of any problem contacting a Authorized Service Center, please see our webpage www.truper.com to get an updated list, or call our toll-free numbers 800 690-6990 or 800 0187-8737 to get information about the nearest Service Center. DE TODO PARA LA CONSTRUCCIÓN FIX FERRETERÍAS... -
Página 12: Warranty Policy
. Transportation costs resulting from compliance of this warranty will be covered by For questions or comments, call 800-690-6990. Made in China. Imported by Truper S.A. de C.V. Parque Industrial 1, Jilotepec, Edo. de Méx. C.P. 54240 Stamp of the business.