Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Operating instructions /
Mechanical
control
model
MODE
The mode knob controls fan speeds and cooling
speeds. To set desired cooling temperature, simply
rotate the mode knob dial to the appropriate
setting.
THERMOSTAT
The thermostat automatically controls the cooling
cycle (compressor) of the air conditioner to maintain
room temperature. However, the fan motor will
continue to operate after the compressor (cooling
cycle) is completed.
LOW FAN will circulate the air at a minimum speed
without cooling.
MED FAN will circulate the air at a middle speed
without cooling.
HIGH FAN will circulate the air at a maximum speed
without cooling.
LOW COOL provides cooling, automatically with
minimum air circulation. Recommended for night-
time use.
MED COOL provides cooling, automatically with
middle air circulation. Recommended for night-
time use.
HIGH COOL provides cooling, automatically with
quick cooling or for extremely hot days. Once room
is cooled, reduce setting to LOW COOL.
OFF will completely shut-off the unit.
NOTE: After setting the mode, allow 3
minutes before switching to another mode.
Fresh Air Ventilation
is usually kept in the closed
position. Use only when clearing smoke and/or
odors from the room. Pull to open.
Thermostat
Mode knob
knob
Fig. 15
!
'
O
!
When using FAN control, turn slowly allowing
unit to adjust.
When using THERMOSTAT,
be sure to allow
three minutes before changing temperature.
Adjusting too quickly may cause an overload
resulting in a blown fuse.
/
/
/
,/
Fresh Air
Vent Lever
Fig. 16
=11
=
Publicidad
Tabla de contenido
