Fcc Compliance - Southwire 60040S Instrucciones De Funcionamiento

Introduction
The Southwire 60040S AC line splitter provides a safe and
easy way to measure the AC current of plug-in appliances and
other electrical devices.
Appliance and lamp power cords have two insulated wire
conductors: the hot or live conductor and the neutral and
ground conductors. Installing a clamp meter around both
conductors will result in a reading of approximately zero amps
because the current flowing through the live or hot wire will
effectively cancel out the current flowing back through the
neutral and ground wires. The Southwire AC line splitter
conveniently "separates" the hot from the neutral and ground
conductors, eliminating the need to physically separate the
wires on the power cord.
The line splitter increases the current reading by ten times
allowing higher resolution when measuring low current.
Remember to divide the current measurement shown on the
clamp meter display by 10. A reminder to "Divide By 10" is
molded into the body of the line splitter.
With proper use, the Southwire AC line splitter will provide
many years of reliable service.
1
WARNING:
• Read, understand and follow Safety Rules and Operating
Instructions in the manual before using this tester.
• The tester's safety features may not protect the user if not
used in accordance with the manufacturer's instructions.
• For use on standard US and Canadian 120 volt AC outlets
only.
• 15 amps AC maximum. Do not test electrical devices that
exceed 15 amps.
International Safety Symbols
Potential danger. Indicates the user must refer to the
manual for important safety information.
Indicates hazardous voltages may be present

FCC COMPLIANCE

Users of this product are cautioned not to make modifications
or changes that are not approved by Southwire Company, LLC.
Doing so may void the compliance of this product with applica-
ble FCC requirements and may result in the loss of the user's
authority to operate the equipment. This device complies with
Part 15 of the FCC rules and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device
must accept any interference received, including interference
that can cause undesired operation.
2