Home Decorators Collection HDR-MUB-11-CH Guía De Uso Y Cuidado

TOOLS REQUIRED
Phillips Head Screwdriver
Drill with 1/16" (1.5mm) bit for
drilling pilot holes
Installation
1
Aligning the Basket
• Place the sliding basket assembly (A) in the cabinet at the
desired location. With a pencil, mark the cabinet floor through
the front two mounting hole locations. Remove the basket
assembly (A) from the cabinet. With a 1/16" drill bit drill pilot
holes through the two mounting hole locations you marked.
1-1/4"
(3.2 cm)
3
Installing the Rear Screws
• Now that the front mounting strap is mounted to the cabinet floor, drill pilot
holes in through the rear mounting hole locations with the 1/16" drill bit.
Fasten the rear mounting strap to the cabinet floor using two mounting
screws (B). Push the multi-use basket all the way back into the cabinet.
Installation is now complete.
Use and Care Guide
Wire Pull-Out Basket
HARDWARE INCLUDED
A - Basket Assembly x1
A
B - Mounting Screw x4
2
Installing Basket to Cabinet
• Pull the multi-use basket completely forward. Place the entire
basket assembly (A) back inside of the cabinet so that the front
mounting holes line directly over the pilot holes you drilled in the
cabinet floor. Fasten the front mounting strap to the cabinet floor
using two mounting screws (B).
B
A
Please contact 1-800-986-3460 for further assistance.
HDR-MUB-11-CH
HDR-MUB-14-CH
HDR-MUB-20-CH
B
HOMEDEPOT.COM/HOMEDECORATORS