Push Button Function - Temper Koban KDP5 Manual Del Usuario

KDP5 remote control
Remote control

Push button function

Note
• Press button to start setting operation.
• By using button, the settings of light level and time can be duplicated to
other detectors.
• Each operation on button can transmit signal for maximum 1sec. No signal
will be transmitted if two or more buttons are pressed simultaneously.
• Presence detector confirms the signal reception by LED flashing for 2sec.
• All the settings for loadⅡ(CH2) are invalid while detector has only one load
(channel).
Button
To set load I (CH1) on for 4hrs or 8hrs
• By pressing ON button, the load of detector will be turned on
for 4hrs or 8hrs depending on the incorporated product.
• Load will be turned off after 4hrs or 8hrs and return to auto
mode. Or press ON button again to exit this "4hrs or 8hrs on
mode" during this period, detector will return to auto mode.
Or switching off power supply of presence detector for 5sec
and re-supply it again to lead detector to auto mode.
• Load I (CH1) can be lead to off mode by pressing OFF button
under on mode.
To set load I (CH1) off for 4hrs or 8hrs
• By pressing OFF button, the load connected to detector will
be turned off for 4hrs or 8hrs depending on the incorporated
product.
• Detector will return to auto mode after 4hrs or 8hrs. Or
press OFF button again to exit this "4hrs or 8hrs off mode"
during this period, detector will return to auto mode.
Or switching off power supply of presence detector for 5sec
and re-supply it again to lead detector to auto mode.
• Load I (CH1) can be lead to on mode by pressing ON button
under off mode.
To lock KDP5 RC buttons
By pressing this button, KDP5 RC buttons will be locked and no
key function is workable (Except
Instructions manual | 14
Function
& buttons).
www.grupotemper.com