Technical Specifications - NATURE & DECOUVERTES 52149600 Manual Del Usuario

EN
PLEASE CAREFULLY READ
THIS MANUAL AND KEEP IT
IN A SAFE PLACE
WARNINGS/CAUTIONS
• DO NOT use the headphones at a high volume for an extended
period.
– To avoid hearing damage, use your headphones at a comfor-
table but moderate volume.
– Lower the volume of the device before placing the
headphones in or on your ears, then progressively increase
the volume to the desired level.
• Be careful and respect the applicable regulations concerning
the use of earphones and headphones with mobile te-
lephones if you use the headphones with a mobile telephone
or to make and receive calls while driving. Certain jurisdic-
tions impose specific limits regarding use while driving, such
as using only one earphone, for example. DO NOT use the
headphones for other purposes while driving.
• Be careful, consider your own safety and that of others while
you are using headphones while performing an activity that
requires your attention, particularly when you are cycling or
The manufacturer is not responsible for any damage caused by improper use.
INTRODUCTION
This set contains:
• 1 set of Bluetooth headphones • 1 instruction manual
®

TECHNICAL SPECIFICATIONS

– Bluetooth®: V 5.0 – Resistance: 16 OHMS
– Transmission distance: 10 m – Speaker size: 10 mm
– Output capacity 100 mAh – Charging time: approximately 2
hours
– Frequency: 20Hz – 20 KHz
– Battery life (in power save mode): 4
– Sensitivity: 95 – 103 DB
to 5 hours
walking on or near to a busy road, a building site, a railway,
etc. Remove the headphones and adjust the volume to be
able to hear the sounds around you, including horns, alarms
and warning signals.
• DO NOT use the headphones if they are emitting an abnormally
loud noise. If applicable, turn off the headphones and contact
your retailer.
• Do not submerge the headphones in water or expose them to
water for prolonged periods, and do not wear them to practice
aquatic sports (swimming, water-skiing, surfing, etc.)
• If you notice any heat or a loss of audio signal, immediately
remove the headphones.
• DO NOT use mobile telephone adaptors to connect the
headphones to the audio system in an airplane cabin. The
resulting heat generated could cause burns or damage the
headphones.
• 1 charging cable
– Battery life (in audio mode): 4
to 5 hours
– Dimensions : 552 x 352 mm
– Adjustable volume
– On/off button
4
BUTTON FUNCTIONS
1. : sound reduction, previous 2.
trackt telephone, hang up, redial
CHARGING
Connect the cable to your computer's USB port (or a USB charger), and your headphone port, where a fixed red LED light will
indicate that the battery is charging. The LED will switch off when the battery is charged.
ON/OFF
1. Switch on
Hold down the button for 3 seconds, the device is switched
on when the blue and red LEDs flash slowly and a sound is
played to indicate «On». The device will then search for a
Bluetooth connection. The Bluetooth headphones will auto-
® ®
matically reconnect to the last telephone if you do not deactivate
your smartphone pairing.
2. Switch off
Once again, hold down the button for 3 seconds, the device
is switched off when the LED is switched off and a sound is
played to indicate «Off».
3. Bluetooth® pairing
For the first connection, hold down the button PLAY/STOP
for 3 seconds to enter connection mode. The blue and red LEDs
flash. The blue LED will do one long flash when the connection
is established. Your Bluetooth device will indicate a Bluetooth
®
connection. To disconnect the device, hold down the button
PLAY/STOP for 3 seconds, until the blue and red LEDs flash.
Repeat the previous operation if you want to connect to a new
device.
COMPATIBILITY
Your product is compatible with the majority of smartphones
and MP3 players. If your telephone does not feature the AVRCP
function, it is possible that the on, off, previous track and next
track functions may not be available.
Note: the AVRCP function (Audio Video Remote Control Profile)
is used to send commands (fast-forward, pause, play, etc.)
from a controller (stereo headphones, for example) to a target
device (for example, a PC equipped with a multimedia player).
: on/off, pause, answer the 3. : increase the volume, next
track
4. Listening to music from your smartphone
Once you have effectively paired your telephone, listen to music
from your telephone. The sound of the music will play from the
Bluetooth ® headphones.
1. Press the button PLAY/STOP once to start the music
playing. Press it a second time to stop it.
2. Press the button once for the previous track, hold it
down longer to reduce the volume. You will hear a low beep
to indicate that the minimum volume has been reached.
3. Press the button once for the next track, hold it down
longer to increase the volume. You will hear a low beep to
indicate that the maximum volume has been reached.
5. Answer the telephone / re-dial a number
1. Once your telephone has been paired, press
®
answer the telephone when receiving an incoming call.
2. Press again to hang up the telephone.
3. To reject an incoming call, hold down
4. During a call, hold down PLAY/STOP to switch the call to
your telephone. Repeat this action to return to the hands-
free Bluetooth mode.
®
In practice, this is what allows you to switch the track directly
from the headphones or the speaker using a dedicated button,
without having to touch the smartphone or tablet that is
playing the music.
CAUTION! Prolonged exposure to high volumes can irreversibly
damage your hearing.
5
once to
PLAY/STOP.