Honeywell Home TL8100 Instrucciones De Instalación

TL8100
7 DAY PROGRAMMABLE HYDRONIC THERMOSTAT
GUIDELINES
TURN OFF POWER TO THE HEATING SYSTEM AT
THE MAIN POWER PANEL TO AVOID ELECTRICAL
SHOCK. INSTALLATION SHOULD BE CARRIED
OUT BY AN ELECTRICIAN.
• For a new installation, choose a location about 5 ft.
(1.5 m) above the floor.
• The thermostat must be installed on an inside wall.
• Avoid locations where there are air drafts (top of
staircase, air outlet), dead air spots (behind a
door), direct sunlight, or concealed chimneys or
stove pipes.
PROCEDURE
1. Loosen the captive screw securing the front
module to the rear module as shown in Fig. 1.
2. Lift the lower part of the front module to remove
it from the rear module.
3. Loosen the captive screw holding the terminal
cover and remove the cover.
4. Pass the wires through the opening to the right
of the terminals. See Fig. 2. Secure the rear
module to an electrical box or to the wall using
the supplied wall anchors and screws.
5. Connect the wires (see section "Thermostat Wir-
ing" on page 2). Use 12 AWG or smaller wire.
14 AWG is recommended for line voltage,
18 AWG is recommended for 24 VAC.
6. Install the terminal cover and tighten the screw.
7. Configure the thermostat using the switches
located on the back of the front module (see
section "Thermostat Configuration" on page 3).
8. Install the batteries (see section "Power-up" on
page 3).
9. Mount the front module onto the rear module
and tighten the screw.
Energy Verified
INSTALLATION INSTRUCTIONS
2
1
4 5
8
7
Fig. 1. Installation steps.
Fig. 2. Routing wires to thermostat.
3
6
9
M29963
SUPPLY
LOAD
PROVIDED
WIRES
M29964
69-2017EFS-05