Taking A Picture - AIPTEK PenCam Ultra Guia De Instalacion

Power up/ down your camera:
camera. To power up your camera, move up the switch; to power down
your camera, move down the switch. Note! You can't power down the
camera before transferring the taken photos to your PC. Once the camera
is powered down, all the stored photos will be lost. Therefore, the taken
photos should be transferred to your PC as soon as possible.
Turn on/ off the LCD:
the camera turns off after 30 seconds of inactivity. The LCD indicates "Lr"
for low resolution (QVGA images) and "Hr" for high resolution(VGA images).
The LCD then displays the number of the remaining pictures.
( Note! Though the camera is turned off, it still consumes electricity. Only by
powering down the camera can stop power consumption. You can power
down the camera after transferring photos to your PC. If your camera is
improperly shut down, power down your camera and then power it up again.)
OFF
Press the shutter switch to take a picture. A high pitched beep indicates that a
picture is taken successfully and the counter decreases as well. A low beep
indicates insufficient light to . A series of beeps suggest that the camera is full.
Power up/down your camera
There is a switch on the upper side of your
Keep pressing SW2 until the LCD is activated, and
ON
(Picture remaining number)

Taking a picture

.. 4 ..