E - Using With Other Automatic Opener Brands - THOMSON 510059 Manual Del Usuario

D - GENERAL CONNECTION
12V SW200D2S Parallel battery connection
Do not connect anything to card's GROUND - /+
SOLAR
BAT
PANEL
COM4
-M2+ -M1+ -Warm+
+12V

E - USING WITH OTHER AUTOMATIC OPENER BRANDS

This power kit can be used with solar-compatible automatic gate openers from brands other than
Avidsen.
Automatic openers must operate exclusively on 12VDC or 24VDC voltage.
This solar kit cannot be used with any other voltage.
Make sure that the circuit board has a backup battery input.
PAY ATTENTION TO THE CONNECTION POLARITY.
Please refer to this manual at all times for wiring the solar kit.
It is best if the circuit board goes into standby mode after a certain amount of time in order to limit power
consumption (refer to the circuit board's technical specifications for more details).
The motor drive may restrict some functionality when running on battery power. If some accessories or
other functions stop working, make sure this is not the cause.
If batteries discharge faster than expected, make sure that no external accessory is using the board for
power (control module, intercom panel, videophone, etc.). If this is the case, you will need to disconnect
them from the circuit board.
10
EN
MOTORISATION
RF2 AUTO
RF1
LD1
COM NC O/C1 O/C2 GND ANT
OC1 OC2
GND
m c o n . s o m o h y t m w . w w
SET THE SWITCH
TO 12V
BATTERY VOLTAGE
24V 12V
batteries
12-24V UNIVERSAL SOLAR KIT
SOLAR IN