NGP SLAL-75-BF Instrucciones De Instalación página 2

2. Install Track and Hardware
• L ine up track flush against jamb on guide door side for 2-door, center track in opening for 4-door
(Track length should be 1/8" less than opening width)
• Place Top pivot bracket and hangers loose in track before securing track with (#8 x 1") screws
• Position top pivot bracket center 2 1/8" from jamb and hand tighten
• Secure bottom bracket in jamb corner with (#8 x 3/4") screws
• Center quick release and pivot plates on door thickness
• Mount top and bottom pivot plates 1 3/4" from center to pivot door edge. (Fig 1)
• Mount quick release plate 1 1/4" from center to guide door edge (Fig 1)
• Secure plates onto door with (#8 x 1 1/2") screws
• D rill 3/16" guide hole in center of guide door and secure
pull with (#8 x 1 3/4") screw (Fig 1)
• To install hinges place doors side by side as if folded.
Secure with (#8 x 7/8") screws. (Fig 2)
3. Hang Doors
• Fold doors together and engage top pivot
into top pivot bracket
• S et bottom pivot assembly into the floor
2 5/8" from the wall
• Slide carrier bolt into quick release mount
plate and close latch