Cooper Lighting MS180 Manual De Instrucciones página 6

MS180_W 825-0216.qxd:MS180 325-1553.qxd
What to do if. . .
Outdoor lights do not come
on with motion at night
Outdoor lights come on for
no apparent reason at night
Lights stay on at night and do
not turn off
Lights continuously blink on
and off at night
Lights are on
during the day
Cannot activate dusk to dawn
mode at night (override)
Call for customer service and/or missing or damaged parts (800-334-6871)
6/26/08 2:58 PM
Is there power to the fixture?
• Check to see that the circuit breaker has not been tripped.
• Be sure the wall switch is in the "ON" position.
• Be sure that the bulb is not burned out or broken.
Is the surrounding external ambient light too bright? (If so
the unit may think it's daytime.)
• Re-aim the head.
• Relocate or reposition the unit away from the light.
TURN OFF POWER BEFORE CONTINUING.
Is the wiring to the fixture loose?
• Check wiring, and reconnect if necessary using wire
nuts provided.
Is there motion in the detection zone?
• Make sure the sensor is not picking up moving objects such
as trees, traffic, etc.
TEST FOR YOURSELF.
• Cover the sensor lens with cardboard to prevent
sensor from detecting motion. If the lights stay off, some
thing in the detection zone is triggering the sensor.
• If this is the case, reduce the sensitivity.
• Reposition motion sensor.
*If the lights stay on with sensor lens covered, contact cus-
tomer service.
Is there motion in the detection zone?
• Make sure the sensor is not picking up moving objects such
as trees, traffic, etc.
• If this is the case, reduce the sensitivity.
• Reposition motion sensor.
If there is no motion, then the unit may be in the override
mode.
• Turn the light switch to the "OFF" position for 40
seconds, and then back to the "ON" position. This will send
the unit back into the AUTO mode.
*If the lights continue to stay on, contact customer service.
The light given off from the unit's own lamp(s) is affecting the
motion sensor.
• Re-aim lamp(s).
• Reposition motion sensor.
Is the switch on the bottom of the motion sensor in the test
mode?
• Move the switch to the 4 MIN or 12 MIN position.
Is the motion detector shadowed?
• Reposition motion sensor.
Is the surrounding external ambient light too bright? (If so the
unit may think it's daytime.)
• Re-aim the head.
• Relocate or reposition the unit away from the light.
Are you allowing adequate time to enter the dusk to dawn
mode?
• Turn power on and off twice within 3 seconds.
Is there more than one fixture on an indoor wall switch?
• If so, put them on separate switches.
6
Page 6
FPO:
Image Copy for Tags