Publicidad
Idiomas disponibles
Idiomas disponibles
PT1016PassThruModuleQSG.book Page 11 Monday, October 15, 2007 3:02 PM
Fiber Optic Cable
50/125 µm (multi-
mode) 500 MHz*km
bandwidth cable
1.
Connect the fiber optic cables to the LC connectors on the
pass-through module.
2.
Connect the other end of the cable to the target Fibre
Channel device.
3. View Status LEDs
The pass-through module contains
several light-emitting diodes (LEDs).
Each SFP contains a pair of green and
yellow LEDs that indicate the status of
the ports on the SFP. Power-on self test
(POST) conditions and results are
summarized in Table 1, Port Status
LEDs.
In addition, at the bottom of the pass-
through module faceplate is one pair of
blue and yellow LEDs that provide the
status of the pass-through module. Pass-
through module status LEDs are shown
in Table 2, Pass-Through Module Status
LEDs.
Note:
For the link rate
conditions, there is a 1-Hz pause when the LED
is off between each group of fast blinks (1, 2 or
3). You should observe the LED sequence for
PT1016 Pass-Through Module Quick Start Guide
and User Manual
Maximum
Minimum
Length
Length
500 meters at
.5 meters
1.0625 Gb/s
300 meters at
2.125 Gb/s
150 meters at
4.25 Gb/s
Connector
LC
Page 11
Publicidad
