Stand Installation - Fox Spirit PGM300 V2 Guía De Usuario

Stand installation

Keep the foam underneath the monitor before attaching the stand.
1. Open the package, take out the accessories and styrofoam, and put them on the desk.
Take out the bottom styrofoam, put the top styrofoam on the desk, don't remove the
monitor from styrofoam.
2. As shown in pictures, lock the base and stand stem by two screws.
Tips: After it's locked, fasten the base decoration part into the base.
3. Screw the stand stem to the hinge.
Tips: Take out the rubber post from the stand before screwing, and then put it back
after it's done.
4. Stand up the monitor carefully.
Tips: Don't catch the screen to protect it being broken.
Top Styrofoam
Bottom Styrofoam
Screw PM4*14mm x2
Screw PM4*14mm x1
ENG-9
Fastener is inside the stand
rubber post