Salient Aquamantys Manual Del Usuario página 2

Aquamantys System Cart Assembly Instructions
Step 1
Lay Support Column (01) horizontally on a hard
surface with handle facing up. Attach the
shorter length stabilizers which have the castors
without wheel locks (08) to base of the hub by
aligning holes in stabilizers with holes in
stabilizer supports protruding from the base of
the Support Column. Use two 10 mm hexagonal
screws (06) per stabilizer. Tighten screws firmly
with large Allen wrench.
Step 2
Turn Support Column (01) over and lay
horizontally on hard surface with handle
facing down. Attach the longer stabilizers
which have the castor with wheel locks (07)
to base of hub by aligning holes in
stabilizers with holes in stabilizer supports
protruding from the base of the Support
Column. Use two 10 mm hexagonal screws
(06) per stabilizer. Tighten screws firmly
with large Allen wrench.
Step 3
Stand partially assembled cart up on its wheels
and engage wheel locks. Loosen set screws (10)
with small Allen wrench and insert infusion stand
(03) through end cap center hole (09) then into the
support column. Advance infusion stand through
both infusion stand clamps (11) until the stand
reaches the hub of the cart. Gentle pressure and
a twisting motion may be required to advance
the infusion stand fully. After the infusion stand is
correctly positioned, tighten set screws (10) with
small Allen wrench, then snap end cap (09) into
support column.
Salient Surgical Technologies, Inc. 180 International Drive Portsmouth, NH 03801 USA
www.salientsurgical.com
2