Chamberlain Group 041D1624-2 Guia De Inicio Rapido

12V Replacement Motor
Model 041D1624-2
To prevent possible SERIOUS INJURY or DEATH:
• Disconnect ALL electric and battery power BEFORE performing ANY
service or maintenance .
To prevent damage to the receiver logic board, DO NOT touch printed
circuit board of replacement receiver logic board during installation .
ALWAYS wear protective gloves and eye protection when changing the
battery or working around the battery compartment .
WARNING: This product can expose you to chemicals including
lead, which are known to the State of California to cause cancer or
birth defects or other reproductive harm . For more information go
to www.P65Warnings.ca.gov
Specifications
Volts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .120 Vac - 60 Hz, Only
Current . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 .5 AMP
Rated Load . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 385 in/ lb ./sec .
Included Items
Motor and Bracket Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (1)
1.
Disconnect power .
2.
3.
Remove the battery cover . Disconnect the
battery (if applicable) . Remove the battery
and set aside (B) .
B
D
C
B
B
4.
Label wires for reinstallation .
Disconnect the wires from the quick
connect terminals (C) .
NOTE: If there is a resistor located on
the green wire traps, do not remove .
5.
Remove the receiver logic board
cover (D) .
1
G
Open the front panel (A) .
A
F
G
8.
Remove the four screws
securing the cover to the
chassis (G) .
E
6.
Unplug the wire
harnesses from the
receiver logic board (E) .
7.
Remove the four screws
securing the receiver
logic board, remove and
discard (F) .
G H
1/4"
screws
5/16"
screws
9.
Remove wires from the motor
bracket . Remove the E-Clip and
push clevis pin down, then remove
G
the 4 screws (5/16" and 1/4")
holding the motor in place (H) .
10.
Lift motor bracket up and off of
the clevis pin, remove chain from
motor sprocket and discard motor .
11.
Reinstall new motor, ensure chain
is on unit sprocket, place chain
over motor sprocket, push clevis
pin into place, install C-clip . Fasten
motor down with 4 screws .
12.
Reinstall the cover . Verify that the
tabs in the cover align with the
holes in the top of the chassis .
Route the wire harnesses and
wires through the cover (G) .
13.
Install the receiver logic board
and connect the wire harnesses .
Ensure the wire harnesses are
connected properly . Route the
antenna through the channel in the
cover . Install receiver logic board
cover .
14.
Reconnect the wires to the quick
connect terminals (C) .
15.
Install the battery (if applicable)
and connect the battery
connectors . Install the battery
cover .
16.
Reconnect power .
Refer to your manual to reset your
travel and force settings .