Carlos Silva DT142I918 Manual De Instrucciones página 2

Carlos Silva SA
MOUNTING
See Fig.2 for mounting details on an operation panel. Before the assembly process, both protective
films must be removed from the plastic lens and the protective film of the screen must be removed
too pulling the red tab.
WIRING
The TFT display has 2 connectors, one off 6-way and one off 4-way. By the 6-way connector (B1) is
energised and wired to the serial bus of the lift controller and this is the only one used in lifts being
dependent of the controller. The 4-way connector (B2) cannot be mounted in the PCB as it will
have a future use as a standalone display. Supply voltage 10-26VDC. Power 0,7W max.
SETUP MENU
Press simultaneously the buttons S1 () and S2 () for 2 seconds to enter in the setup menu. The
menu is left after a few seconds of inactivity or by selecting EXIT in the main menu. The S1 and S2
buttons are used to navigate and search the proper value. The S3 button is used to select and
accept the value. If the connector B2 is not mounted, the only valid mode is the dependent mode
(MODE SELECTIONMODE: Controller dependent). The default language is English but it can be
changed to Spanish selecting ES in the LANGUAGE entry.
MODULE ADDRESS
The display address is set in the menu at CONTROLLER DEPENDENT MODE  ADDRESS. This model
has no microswitches to determine its address. In dependent mode, is recommend set the address
value to 20 if used in cabin and to 00 if used at landing.
BACKGROUND AND SYMBOLS COLOURS
The background colour and the colour of the symbols are adjustable through the setup menu. The
RGB code of the desired colours can be entered in SCREENBACKGROUND COLOUR and
SCREENSYMBOL COLOUR. To set a colour is required to adjust each of the three colour
components (R=red, G=green, B=blue). The following table contains some examples of colours with
their corresponding codes:
Colour R G
Black 0 0
Grey 128 128
White 255 255
Silver 192 192
Golden 255 215
Ochre 204 119
INDICATION LEDs
In dependent mode, the RX LED (green) indicates that the display receives data sent by the lift
controller, so their activity confirms the correct wiring to the bus, and the ST LED (red) indicates
that the display is receiving correct messages addressed to it, therefore its activity confirms that the
selected address contains messages for the display.
ADDITIONAL INFORMATION
Additional information about this display module can be found in the download area of the site
www.carlos-silva.com
EN
TFT 2,8" – Colour graphic display
B Colour
0 Red
128 Lime
255 Blue
192 Green
0 Olive
34 Cyan
DT142I918
R G B
255 0 0
0 255 0
0 0 255
0 128 0
128 128 0
0 255 255
Colour R G
Navy 0 0
Teal 0 128
Purple 128 0
Brown 128 0
Yellow 255 255
Fuchsia 255 0
B
128
128
128
0
0
255