Cleaning And Maintenance; Spare Parts - Renfert Vario E Instrucciones De Uso Originales

Notes / Tips on Operation:
• Opaque waxes may separate while heating in the Vario E. Before beginning work, use an instru-
ment to stir these types ofwaxes.
EN
• Wax can be most easily removed shortly after the unit is switched on. Once the wax has begun to
melt around the edges, the wax cylinder can simply be removed.
• When carving the edges of crowns, the pot rims on the Vario E are ideally suited to warm the
instrument (this prevents the instrument from becoming excessively hot, as can occur when
an open flame is used). Within seconds, the instrument will be warm to the touch; the ideal tempe-
rature for working on the wax crown edge.
• Quickly withdrawing the instrument from the Vario E = Larger wax beads; Slowly withdrawing the
instrument from the Vario E = Smaller wax beads.
• To speed the melting process, always close the lid on the wax pot during the melting phase.
• If the wax liquefied in the Vario E is processed with Waxlectric modelling instruments, the proces-
sing temperature of the electric wax knife can be significantly reduced, since the knife no longer
needs to supply the energy required to melt the wax.
Tips on Dipping:
• Do a quick dip to just beyond the preparation border.
• Slowly and evenly remove the die from the wax.
• Just before the tip comes out, hold it steady in the pot for a short time so that any excess wax can
drop down.
6

Cleaning and Maintenance

The Vario E is maintenance free. From time-to-time, you should wipe your unit down with a damp cloth.
Never use detergents or solvents!
Never rinse or spray your Vario E directly with water.
With the unit switched off, you can remove hardened wax residue by carefully
scraping it.
Warming the unit's surfaces with a hair drier will make it easier to remove wax residue.
The lid of your Vario E can be removed for gently cleaning with the steam jet.
7

Spare Parts

You can find components subject to wear and the spare parts on the spare part list in the
internet at www.renfert.com/p918.
Enter the following item number: 14520000 or 14521000.
The components excluded from the warranty (such as consumables or parts subject to wear
and tear) are marked on the spare part list.
Serial number and date of manufacturing are shown on the type plate of the unit.
8 Warranty
Provided the unit is properly used, Renfert warrants the Vario E for a period of 3 years. The original sales
invoice of the specialist depot is required for a claim under guarantee.
Components subject to natural wear are excluded from this warranty.
The warranty is voided in case of improper use; failure to observe the operating, cleaning, maintenance,
and connection instructions; in case of independent repairs or repairs by unauthorized personnel; if spare
parts from other manufacturers are employed, or; in case of unusual influences or influences not in com-
pliance with the utilization instructions. Warranty service shall not extend the original warranty.
- 4 -