An electrical wire in the
motor terminal board is
disconnected
An electrical wire in the
electrical panel is
disconnected
The ON switch is faulty
A fuse has blown
The thermal safety
device has been
triggered
Difficult trolley
Dirty runners
horizontal sliding
No cooling water
Refer to "cleaning and maintenance of the
reaching disc
The disc is worn
Disc fails to cut
Transmission belt not
tensioned
Motor starts but disc
Belt broken
does not turn
* Operation to be carried out by an electrician
Tools supplied
• double-ended wrench CH 10-13
• open ended wrench CH 36
IMER INTERNATIONAL S.p.A
Restore the
connection *
Restore the
connection *
Replace the switch *
Replace the fuse *
Wait a few minutes
and try again
Clean the runners
cooling system" (par. 17.5)
Replace with new
disc
Tighten the belts
Replacing the drive
belt
8