Maintenance
When the pre-installed, rechargeable Nickel-metal Hydride (Ni-MH) batteries have reached the end of their useful
life, they can be easily replaced.
□
This unit requires three AA, 1200mAh Ni-MH replacement batteries, which can be purchased at The Home
Depot.
□
Disconnect the light from the solar panel, and unmount from its position, placing the light on a sturdy
surface.
□
Unscrew and remove the back panel to access the batteries, and remove the batteries from the cradle.
□
Place the new Ni-MH batteries in the cradle, being careful to align the positive/negative poles to their
corresponding icons in the cradle.
□
Replace the rear cover, screwing it securely into position. Remount the light, connect the solar panel, and
follow the installation instructions.
□
Properly dispose of the depleted Ni-MH batteries.
Care and Cleaning
□
To prolong the original appearance, clean the light fixture with clear water and a soft, damp cloth only.
□
Periodically clean the solar panel with a soft cloth and warm water. Do not hose spray. Keep the panel clear of
snow and leaves. Make sure trees and other objects do not block sunlight from the panel.
□
Do not use paints, solvents, or other chemicals on this light fixture. They could cause a premature
deterioration of the finish. This is not a defect in the finish and will not be covered by the warranty.
□
Do not spray the light fixture with a hose or power washer.
□
If not to be used for several weeks, turn the unit OFF. Store it with the panel connected and where the panel
can gather sunlight.
14