Troubleshooting - Insignia NS-IMN44SS2 Guia Del Usuario

Troubleshooting

CAUTION: Do not try to repair your ice maker yourself. Doing so invalidates the warranty.
PROBLEM POSSIBLE CAUSE
The "Add Water" No water in the reservoir.
indicator lights
The ice has a bad Various
taste or there is
an odor
The "Ice Full" Too much ice in the
indicator lights drawer.
or flashes
With no ice in the drawer.
The ice making The room temperature or
cycle is normal, water temperature may be
but no ice is too high.
made
The refrigerant liquid may
have leaked.
A pipe in the cooling
system may be blocked.
The LIGHT and The ambient temperature
ICE icons blink or the water temperature
in the inner tank is too
high.
Refrigerant liquid leakage.
The motor cover is broken.
A pipe in the cooling
system is broken.
Makes ice too The hot air outlet is
slowly blocked.
The water temperature in
the inner tank is too high.
The refrigeration system
has a malfunction.
Your ice maker is The drain plug is loose or
leaking water missing.
A pipe joint in the ice
maker may be loose.
The seal has reached the
end of its service life.
Máquina de hacer cubitos de hielo portátil de 44 lb
POSSIBLE SOLUTION
Turn off your ice maker, remove the ice drawer,
add water to the reservoir, replace the drawer,
then press the
ice.
• Make a few loads of ice after unpacking and
discard the ice
• Clean the ice maker
• Use filtered water
Remove some ice from the drawer.
Something is blocking the infrared light in the
ice drawer. Remove the obstacle from the ice
drawer or clean the inside of the drawer.
Press the
override). Makes ice for 80 minutes.
The room temperature should be 50° F ~ 105° F
(10° C ~ 40° C). The water temperature should be
45° F ~ 90° F (7° C ~ 32° C).
Contact a qualified service technician for repair.
Contact a qualified service technician for repair.
The ice maker should be operated below 90° F
(32° C) ambient temperature.
Pour colder water into the tank.
Press the
making process, then wait for 50 minutes. If the
problem does not resolve itself, have your ice
maker serviced by a qualified technician.
Check the hot air outlet and remove any
blockage.
The water temperature must be between 45°
and 90° F (7° and 32° C)
Have your ice maker serviced by a qualified
technician.
Replace the drain plug into the drain line.
Have your ice maker serviced by a qualified
technician.
Have your ice maker serviced by a qualified
technician.
www.insigniaproducts.com
ICE button to begin making
(ICE) button for five seconds (to
(ICE) button twice to restart the ice
11