Steren SPK-640 Manual Del Usuario página 3

INSTALLATION
Make sure to set the volume level in the amplifi er, to the
minimum, later you can adjust it in accord to your necessities.
1.- Check each one of the parts of the speaker and obtain the
necessary tools (stiff wire, wire strippers).
2.- Make sure the cables from the amplifi er reaches the place
where you want to install the speaker.
3.- Once the cables from the amplifi er are correctly installed in
the desired place, hang up the speaker. Make sure the protector
case from the speaker is in the lowest point of the holder.
4.- The black cable must be connected to the common
connector, the red cable goes to 3W output and the brown cable
should be connected to 6W output; connect his cables in accord
to your necessities.
5.- If you need to use cable extensions, you can use from caliber
22 to 18, depending of the placing distance and the number of
speakers you want to install.
6.- If you use cable extensions, make sure to insulate the
connections.
7.- Once you have done the connections, pick up the protector
case and the rubber in order to cover the installation. The
minimum distance to place the cover is 210mm and the
maximum is 400mm.
8.- Turn the amplifi er on and playback a CD, gradually set the
volume level, the music will be listened through the speaker.
Hang up
ENGLISH-3