Display Information In Stand-By Mode - KSenia KSI2100021.312 Manual Usuario

DISPLAY INFORMATION IN STAND-BY MODE

FIRST ROW OF THE DISPLAY
SYSTEM OK
EN CONFIGURAZIONE
TAMPER
ALARM!
MISSING PERIPH.
TAMPER MEMORY
ALARM MEMORY
SYSTEM FAULTS
FAULT MEMORY
ENTRY TIME
EXIT TIME
WARNING TIME
PHONE CALL ACTIVE
ZONE BYP/TEST
ACTION BLOCKED
ALARM BLOCKED
INFOS AVAILABLE
There are no faults
The control panel is processing and applying a new
configuration.
Tamper in progress on at least one of the partitions
enabled for the keypad.
Alarm in progress on at least one of the partitions
enabled for the keypad.
At least one BUS peripheral is missing or wireless
peripheral does not communicate correctly with the
control panel.
At least one tamper memory is present.
Alarm memory on at least one of the partitions enabled
for the keypad.
The system has at least one fault.
The memory of a fault now restored, is present.
Entry time is active on at least one of the partitions
enabled for the keypad.
Exit time is active on at least one of the partitions
enabled for the keypad.
Warning time is active on at least one of the partitions
enabled for the keypad
A telephone call is in progress.
At least one zone is in test or manually bypassed
The installer blocked the panel actions.
The installer blocked the panel alarm actions.
This information is visible only if the panel was
programmed to be EN50131 grade 3 compliant. In this
case the system status can't be displayed, so this
information means that there is something to check in
the system.
24