Phoenix Gold Z Serie Guia De Inicio Rapido página 2

SPECIFICATION
Peak Power (watts)
Rated Power (watts)
Frequency Response
Impedance
Sensitivity
Cone Material
Tweeter
Mounting Depth
Mounting Diameter
INSTALLATION GUIDELINES
Ensure the audio system is turned off before making any connections to the amplifier, speakers or
source unit. Failure to do so could result in permanent damage to the audio system.
When wiring the speakers ensure that the wire is protected from sharp objects and always use rubber
grommets when wiring through metal panels. Ensure all terminals and connections are
protected from the vehicle chassis and from each other as failure to do so could result in
permanent damage to the audio system.
When connecting speakers to the source unit or amplifier ensure you connect the positive and
negative output wire from the source unit to the corresponding speaker terminals. This will ensure
the audio system will be in phase.
1. Ensure there is adequate clearance and depth for the speaker to be mounted.
2. Use the supplied template to mark out & cut the correct diameter hole.
3. Drill four holes for the mounting screws.
4. Separate the grille from the frame
5. Insert the speaker and grille and affix with the screws provided
6. Complete installation by replacing the grille into the grille frame.
© 2017 Phoenix Gold • www.phoenixgold.com
Z5CS Z65CS
140 Watts 160 Watts
35 Watts 40 Watts
41Hz-26KHz 35Hz-26KHz
4 Ohm 4 Ohm
85dB 86dB
Polypropylene Polypropylene
PEI PEI
45mm / 1.77" 46mm / 1.81"
118mm / 4.64" 126mm / 4.96"
9 3/8"
9mm (0.35")
u
20 13/16"
20mm (0.78")
u
Z-Series Component Speakers
p Component Fixing
t Tweeter Dimensions