NORTH STATES 4929 Instrucciones página 7

If the gate does not stay closed, verify that the mark in the le upper corner of the gate is aligned with the mark on the
upper locking housing, as shown in Figure 12C.
If the mark on the le upper corner does not align with the mark on the upper locking housing, please make the
adjustments below to ensure that the door panel can be auto closed.
If the upper locking housing is offset toward the right (12
then adjust the door panel and upper locking housing un the two marks are aligned (12C Make certain to re hten the
screw (12
Figure12A
upper locking
left upper corner
housing
12C
If the upper locking housing is misaligned upward (12E or downward (12
hinge (12G then press the door panel and the door lower hinge together (12H un the two marks on the le corner are
aligned. Make sure the screw is re htened.
upper locking
12E
housing
Care
CLEANING
Clean the Superyard using warm water and a mild detergent. Use a so cloth or sponge to avoid scratches. Never use
solvents or chemicals to clean the Superyard.
12B
door
left upper corner
panel
12D
12F
upper locking
housing
Distributed exclusively in the United States by
North States Industries, Inc.
5455 Highway
Plymouth, MN 55442
www.northstatesind.com
Manufactured in China
or le (12 B , please loosen the screw on upper locking housing ,
upper locking
door
housing
panel
please loosen the screw on the door lower
12G
door lower
hinge
N
Note Please use two
screwdrivers when tening
or loosening the screws (12
12H
Page 7