Cleaning Instructions; Tools & Equipment; During Assembly - Palram Martinique Manual De Instrucciones

EN
IMPORTANT
Please read these instructions carefully before you start to assemble this product.
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.
» Care & Safety Advice
•
Please follow the instructions as listed in this manual.
•
Sort the parts and check against the contents list.
•
For safety purposes we strongly recommend the product to be assembled by
at least two people.
•
Some parts have metal edges. Please be careful when handling components.
•
Always wear gloves, shoes and safety goggles during assembly.
•
Do not attempt to assemble the Gazebo in windy or wet conditions.
•
Dispose of all plastic bags safely – keep them away from children's reach.
•
Keep children away from the assembly area.
•
Do not attempt to assemble the Gazebo if you are tired, have taken drugs,
medications or alcohol, or if you are prone to dizzy spells.
•
When using a stepladder or power tools, make sure that you are following the
manufacturer's safety advice.
•
Do not climb or stand on the roof.
•
Heavy articles should not be leaned against the poles.
•
Keep roof and gutters clean of snow, dirt & leaves.
•
Heavy snow load on roof can damage the Gazebo, making it unsafe to stand
below or nearby.
•
This product was designed to be used mainly as a Gazebo.
If color was scratched during assembly it can be fixed with the following tints:
Grey – RAL 7012
» Cleaning Instructions
In order to clean the Gazebo, use a mild detergent solution and rinse with
cold clean water.
Do not use acetone, abrasive cleaners, or other special detergents to clean
the panels.
» Tools & Equipment
TOO1(Supplied)
5mm
3/16"
SILICON \
13mm
CAULK
10mm
25/64"
Attention
•
Please note you install the panels with the UV protected side out
(marked with "THIS SIDE OUT") and peel the film strip covering the panels.
•
Screws and plugs are not supplied.
•
Please tighten all screws when completing assembly.
•
Anchoring this product to the ground is essential to its stability and rigidity.
It is required to complete this stage in order for your warranty to be valid.
» During Assembly
During assembly use a soft surface below the parts to avoid scratches and
damages.
When encountering the information icon, please refer to the
relevant assembly step for additional comments and assistance.
Step 6b: Carefully spread silicone along the cross-section of the profile and
immediately attach the profiles together. It is recommended to wipe the extra
residue silicone.
Step 7+12: It is recommended to use a carton or other soft material under the
lowered corner in order to avoid scratches and peeling of paint.
*This note also refers to steps 9,10,12
Step 10: Optional - if you wish to add curtains / mosquito netting -
Please thread the plastic clips through the rail in each profile.
(Curtains / mosquito netting are not supplied).
Add clips according to the specific quantity of curtain rings.
Steps 12a+14a: Please note that screws insertion should be done from the
outside.
Steps 13+15: Please note that screws insertion should be done from the bottom
up. Afterwards please use the tool T001.
Step 16b: Please add silicone on the inner area of part #8327 as illustrated.
Step 22a: Please drill holes in the panels to be located precisely parallel to the
holes in profiles #7663.
Step 23: Please level the profile's legs and adapt screws and plugs to your specific
ground type.