Sunbeam Igloo Ice Shaver Manual De Instrucciones página 3

HOw TO USE YOUR IGLOO ICE SHAVER
1. Clean all components prior to first using
(See HOW TO CLEAN YOUR IGLOO
ICE SHAVER).
2. Lift the POWER PUSH BUTTON LID
and place 4 - 6 ice cubes into the unit,
leaving about 1 inch from the top.
3. Place a wide-mouth cup under the ice
chute to catch the shaved ice.
4. Plug unit into electrical outlet.
5. Be sure that the top and bottom housings
are properly aligned. If the housings are
not aligned correctly the unit will not
activate.
NOTE: Never move the housing when in use.
6. Place a cup underneath the chute. Press the POWER PUSH
BUTTON LID at the "PUSH" position to start making
shaved ice.
7. Clean all excess ice/water from unit after use. (See HOW
TO CLEAN YOUR IGLOO ICE SHAVER).
NOTE: Occasionally ice may build up and will get lodged in the
chute.
If ice is not coming out of the chute gently shake the unit to
ensure the ice is not frozen together.
CAUTION: Do not allow children to operate this appliance.
The Ice Shaver is for household use only. Do not attempt to
sharpen the BLADE.
Sunbeam Igloo Ice Shaver_11ESM1.indd 5-6
4
HOw TO CLEAn YOUR IGLOO ICE SHAVER
CAUTION: The stainless steel BLADE is very sharp. Never
attempt to touch the tip of the BLADE when operating,
assembling, disassembling, or cleaning.
1. Make sure the unit is unplugged.
2. Unlock COVER by pressing the COVER RELEASE PUSH
BUTTON located on the back side of the unit. Lift to
remove.
3. To remove DASHER, turn the UPPER HOUSING slightly
clockwise until it clicks. This will indicate that the gears are
locked in place. Unscrew DASHER by turning counter-
clockwise.
4. Remove UPPER HOUSING by further turning clockwise
and lifting.
5. Wipe down all parts and surfaces with a clean damp cloth.
CAUTION: Do not immerse unit in water.
To reassemble: Reverse the above procedure making sure that
the UPPER HOUSING is locked and aligned with the LOWER
HOUSING.
Questions? Please contact us at www.sunbeam.com
or at 1.800.458.8407.
5
10/20/11 9:39 AM