Senco DURASPIN DS230 Instrucciones De Operación página 14

Slide mechanism "sticks" or
returns slowly
Pushing force becomes excessive
Attachment will not fully
install/lock
Attachment will not fully
uninstall/unlock
Attachment will not rotate/index
independently of connector
Debris build-up in mechanism
Weak return spring
Bit sticking in collation material
Improper screw for application
CAM screw is loose or damaged
Debris build-up on mechanism
The attachment is not fully insert-
ed and seated onto the tool
The collar is not turned to the full
unlock position
Foreign object stuck inside
attachment
Components in connector may be
damaged
The collar is not turned to the full
unlock position
The attachment is catching on the
front end of the tool
Foreign object stuck inside
attachment
Components in connector may be
damaged
Damage or failure of indexing
components
14
Clean mechanism
Replace or return to Senco
authorized service centre for repair
Use Senco branded fasteners for
optimum performance
Always attempt to store screws
in cool, dry place before use.
Overheated collation can get soft
and cause a delay in feed system
return
Consider alternative fastener
Tighten or replace CAM screw
Clean mechanism
Verify that the attachment is fully
seated before attempting to lock
the collar
Partially install tool as far on as
possible and rotate the collar to
full unlock position
Make sure that no objects or parts
are jammed inside the connection
Replace connector or return to
Senco Authorized service centre
for repair
Rotate the collar to full unlock
position
Avoid removing at any angle, pull
attachment straight off and away
from the tool to remove
When in full unlock position,
maneuver attachment up and
down to disengage grabbing
features from tool
Be sure that no objects or parts
are jammed inside the connection
Replace connector or return to
Senco Authorized service centre
for repair
Replace connector or return to
Senco Authorized service centre
for repair