Spyder Sonix&Sonix PRO Manual De Instrucciones página 9

English
Quick Clean Disassemble
Lift upward on the Top Cocking knob (#STK002). This will allow the Delrin Bolt (#VBT005) sliding from the rear
of the Receiver. HELPFUL TIP: With the Delrin Bolt removed out of the Receiver, this allows easy access to clean
with a squeegee. NOTE: Make sure the hole on the Striker Bolt (#STB002) is facing upright when looking thru the
Receiver. This will allow the Top Cocking Knob (#STK002) to correctly fasten with the Striker Bolt. HELPFUL TIP:
Please note how the parts are removed for easy reassembly
Disassemble Rear Internals
STEP 1 Lift upward on the Top Cocking knob (#STK002). This will allow the Delrin Bolt (#VBT005) slide out from
the rear of the Receiver.
STEP 2 Remove the Quick Disconnect Pin (#RPN008). This will allow the Striker Plug (#STP007 or #STP025)
and the markers internals to side from the rear of the Receiver. NOTE: Remove the Quick Disconnect Pin when the
markers in the de-cocked position. This way, the tension of the Striker Spring does not allow the markers internals
to spring out. HELPFUL TIP: Placing your finger behind the Striker Plug before removing the Quick Disconnect Pin
will prevent the markers internals to spring out.
STEP 3 Remove items in order; Striker Plug (#STP007 or #STP025) w / Velocity Adjuster (#VTA007 or
#VTA016), Striker Spring (#SPR004) and Striker Buffer (#STF001).
STEP 4 Slide the Striker Bolt (#STB002) out of the rear of the Receiver.
HELPFUL TIP: When the internals are
removed it would be wise to clean any dirt or paint from the inside of the Receiver with a squeegee. Wipe clean the
Delrin Bolt with a rag or paper towel. Apply some paintball gun on the Striker O-ring periodically.
Reassemble Rear Internals
STEP 1 Insert the Striker Bolt thru the rear of the Receiver with the o-ring facing towards the front of the marker.
NOTE: When inserting the Striker Bolt, apply pressure behind the Striker Bolt and at the same time pull on the
Trigger (#TRF003) to allow entry of the Striker Bolt. NOTE: The hole on the Striker Bolt should be facing upright
when looking thru the Receiver. This will allow the Top Cocking Knob to correctly fasten with the Striker Bolt.
STEP 2 Insert the Striker Buffer flush with the Receiver and place the Striker Spring thru the Striker Buffer.
STEP 3 Place the Striker Plug w / Velocity Adjuster & Spring Guide to the rear of the Receiver.
STEP 4 Insert the Quick Disconnect Pin thru the Receiver to hold the Striker Plug in place.
STEP 5 Insert the Delrin Bolt thru the rear of the Receiver with the Top Cocking Knob. Press downward on the
Top Cocking Knob to gain entry with the Striker Bolt. NOTE: If the Striker Bolt hole is not aligned upright, the Top
Cocking Knob will not fasten correctly with the Striker Bolt. HELPFUL TIP: Use a small tool devise to align the hole
upright should the Striker Bolt turn when positioned back in the Receiver. IMPORTANT: The Quick Disconnect Pin
must be properly placed thru the Receiver. The ball bearing on the pin must be visible thru the opposite end of the
Receiver.
To assure marker is assembled properly, follow the schematic drawing or position parts in order during disassembly.
Parts assembled backwards or improper parts installed will / can cause the marker to malfunction.
WARNING
Never attempt to remove the markers internals while the CO2 / Compressed Air Tank is attached. Make sure to
remove all paintballs and loader before disassembling the marker.
6