Channel Selection - LEXIBOOK WB400 Manual De Instrucciones

3. If the main unit does not display the readings after 3 minutes, in normal mode
(the full display of all readings), press
temperature section is displayed. Press and hold
synchronize manually the remote sensor and the main unit.
it is searching for the sensor signal. You can also press the TX switch in the
sensor battery compartment to initiate the sensor to send its signal to the
main unit.
Note:
• appears next to the temperature display.
• appears next to the humidity display.
Non-rechargeable batteries are not to be recharged. Rechargeable batteries
are to be removed from the product before being charged. Rechargeable
batteries are only to be charged under adult supervision. Different types of
batteries or new and used batteries are not to be mixed.Only batteries of the
same or equivalent type as recommended are to be used. Batteries are to
be inserted with the correct polarity. Exhausted batteries are to be removed
from the product. The supply terminals are not to be short-circuited. Do not
throw batteries into a fire. Remove the batteries if you are not going to use the
product for a long period of time.
WARNING: Malfunction or loss of memory may be caused by strong frequency
interference or electrostatic discharge. Should any abnormal function occur, reset
the unit or remove the batteries and insert them again, or unplug the AC / DC
adapter from the mains socket and plug it back in.
The WB400 comes with 1 remote sensor. The sensor's default channel is
channel 1 and does not need to be changed.
The channel function allows you to use up to 3 additional sensors. The main unit
can identify each remote sensor thanks to their assigned channel (channel 1,
2 or 3). If you have 1 or 2 additional sensors, you can place them in a different
location in your house such as in a bedroom. Your main unit can collect the
temperature and humidity data of up to 3 remote sensors.
Adding a sensor
1. Set the sensor to an unused channel by sliding the CHANNEL selector
switch in the sensor's battery compartment to the desired number.
2. In normal mode (idle screen) on the main unit, press
outdoor temperature section.
MODE

CHANNEL SELECTION

4 times so that only the outdoor
for 2 or 3 seconds to
MODE
4 times to go to the
MODE
flashes while
7