Making A Phone Call - BENQ-SIEMENS HHB-700 Manual De Instrucciones

8 Headset PTT Bluetooth
Registering the headset with
a mobile phone
The headset must be switched
off.
1. Press the ptt button for at
least 6 seconds. The LED
lights up steadily, and two
high tones can be heard. Your
mobile phone can now "look
for" the Bluetooth Headset.
2. Activate search mode on your
mobile phone. Please read the
notes in your mobile phone
manual.
3. If your mobile phone finds
your headset, this is shown on
the mobile telephone display
beneath the device name
HHB-700.
If your mobile phone does not find the
headset within 3 minutes, activate
search mode again (repeat step 1).
4. If requested, enter the
password (PIN) for the
headset into your mobile
phone:
0000
The Bluetooth Headset is now
registered to your mobile phone.
®
(en)

Making a phone call

You can only make calls with
the headset if the headset is
switched on (see on left) and if
the headset is registered with a
mobile phone (p. 8).
The procedure described below
only applies to Siemens mobile
phones. It may be different for
other manufacturers' mobiles.
The following symbols are used
to explain how to operate the
headset:
b
• You will know the call is about to
drop if the signal quality is poor.
• If the mobile phone is not
connected to the network, you will
hear a recurring beep tone in the
headset.
• If the Bluetooth connection to the
mobile phone is interrupted for
several seconds during a call, you
can only continue the call with the
mobile phone.
This function varies from
service provider to service
provider. You may need to
register separately for this
service.