Urmet Yokis hub Guía De Puesta En Servicio Rápida página 9

How to configure
Prerequisites:
▶ Power all modules on the
same phase
Led
Connect
▶ Power the YOKISHUB on the same phase used for the modules.
NOTE: The YOKISHUB must NOT have been previously configured using the YOKISPRO
App. Any configuration using the YOKISPRO App will inhibit the possibility of
using the rapid installation method. Even the HOW TO RESET THE YOKISHUB
CONFIGURATION PROCEDURE (see below) will not allow you to return to fast
commissioning programming conditions.
Step 1: Set the YOKISHUB to learn mode
▶ Hold symbol
on the YOKISHUB pressed for 3 seconds.
The two LEDs will flash alternately to indicate that the YOKISHUB is in learning mode.
URMET S.p.a., Via Bologna 188/C, 10154 Torino - Customer Service: +39 011 23 39 810
Export Dept. Phone: +39 011 24 00 250/256 - Fax: +39 011 24 00 296 - www.yokis.com
QUICK START GUIDE
without using App (max. 10 modules)*
*for unlimited installations, use the
N
L
230V
3 seconds
DS1054-043C
▶ Connect the YOKISHUB to the ADSL Gateway.
P O W E R W L A N I N T E R N E T L A N
1 2 3 4
YOKISHUB
LED
GB
App
1 seconde 1 second
9