Auto Install Radio Stations; Set Clock; Turn On - Philips DCM292 Manual Del Usuario

the DC IN jack on the main unit.
the wall outlet.

Auto install radio stations

When you connect power and no radio
stations are stored, the unit automatically begins
to store radio stations.
1
Connect the unit to the power supply.
» AUTO INSTALL PRESS -- PLAY
[
KEY](auto install press -- play key) is
displayed.
2
Press on the main unit to start
installation.
»
The unit automatically stores radio
»
When all the available radio stations
is broadcast automatically.

Set clock

Note
You can set the clock in the standby mode
only.
1
Press and hold PROG/CLOCK SET to
enter the clock setting mode.
» SET CLOCK](set clock) scrolls on the
[
screen.
2
Press / repeatedly to select 12 hour
or 24 hour format.
3
Press PROG/CLOCK SET
»
The hour digits are displayed and begin
to blink.
4
Press / to set the hour.
5
Press PROG/CLOCK SET
»
The minute digits are displayed and
begin to blink.
6
Press / to set the minute.
7
Press PROG/CLOCK SET
clock setting.

Turn on

1
Press .
»
The unit switches to the last selected
source.
Switch to standby
1
Press again to switch the unit to
standby mode.
»
The clock (if set) appears on the
display panel.
To switch the unit to Eco Power Standby
mode:
1
Press and hold
seconds.
»
The backlight on the display panel
turns off.
Tip
The unit switches to Eco Power Standby mode
after 15 minutes in standby mode.
To switch between standby mode and Eco
Standby Mode:
1
Press and hold
seconds.
for more than 2
for more than 2
EN 13