Appendix 3 - Tripp-Lite MODBUSCARDSV Operación Manual

Appendix 3

Code(FF) Name
01 cBusOver
02 cBusUnder
03 cBusUnbalance
04 cBusShort
06 cBusSoftTimeOut
07 cInvSoftTimeOut
08 cInvVoltHigh
09 cInvVoltLow
10 cRInvVoltShort
11 cSInvVoltShort
12 cTInvVoltShort
13 cRSInvVoltShort
14 cSTInvVoltShort
15 cTRInvVoltShort
16 cInvRNegPow
17 cInvSNegPow
18 cInvTNegPow
19 cOverLoadFault
20 cBatteryFault
22 cOverTemperature
25 cCanFault
26 cSynSigFault
27 cTRIG0Fault
28 cRelayFault
29 cLineSCRFail
31 cSPSFault
32 cParaCableLoosenFault
33 cDSPMCUStopComm
34 cBypassSCRFault
35 cBypassTemperatureFault
36 cInvVoltOver
Definition
BUS Voltage is over 450V
BUS Voltage is under 320V, 200 ms
+BUS, -BUS difference is over 50V, 200 ms
Hardware Signal Trigged
BUS soft-start time is over 120 sec
Inverter soft-start time is over 120 sec
Inverter RMS is over 250V, 200 ms
Inverter RMS is under 150V, 200 ms
R-phase voltage is less 70V and current is over 50A
S-phase Voltage is less 70V and Current is over 50A
T-phase Voltage is less 70V and Current is over 50A
RS-phase Voltage is less 70V and Current is over 50A
ST-phase Voltage is less 70V and Current is over 50A
TR-phase Voltage is less 70V and Current is over 50A
800W, 40 ms; 400W, 100 ms
800W, 40 ms; 400W, 100 ms
800W, 40 ms; 400W, 100 ms
Overload occured, but bypass is not good
Battery is connected reversely
The max. temperature sensor is over 80°C
CAN bus is abnormal and droop source needs to be changed
SYNCHRO Signal Fail
TRIG0 Signal
Inverter Relay Short
I/P SCR is Open
SPS output is abnormal
Parallel Cable is loose
DSP and MCU do not communicate
STS Bypass SCR fail
STS is over-temperature
Inverter Sample voltage is over 380V, 156 us
1111 W. 35th Street, Chicago, IL 60609 USA • tripplite.com/support
12
19-07-265 93-39CA_RevA