Installation Instructions - HomeNetWerks 75-101-BT Manual Del Usuario

INSTALLATION INSTRUCTIONS

INSTALLING THE Z-BAR FOR HANGING MIRROR
1. Place the Z-bar (D) at the desired location on the wall,
using a level for final positioning. Mark the location of
the three holes in the Z-bar (D) on the wall. Drill 1/4 in.
holes at the marked locations and insert included
wall anchors (B). Secure Z-bar (D) to the
wall with three included screws (C).
INSTALL LOWER LOCKING SCREW
2. Using a level, mark down from the center of the Z-bar
(D) 22-3/4 in. for vertical mirror orientation (see
FIGURE 1). Drill a 1/4 in. hole at this location and
insert an included wall anchor (B). Drive the lower
locking screw (E) into the anchor (B), leaving 1/2 in.
exposed (see FIGURE 1).
MIRROR WIRING
3. Locate the White (neutral), Black (live) and Green
(ground) wires are extended from the cord in the back of
the mirror. With the power turned off, connect the wires
on the mirror with the neutral, live and ground house
wires with wire connectors (included).
HANG AND SECURE THE MIRROR
4. Hang mirror on the Z-bar (D), centering it and ensuring
that it is securely hanging (see FIGURE 2). The lower
locking screw (E) will align with the key-hole bracket on
the lower back of mirror. Once the lower locking screw
(E) is aligned through the key-hole slot, move the
mirror slightly to either side to lock it in place
(see FIGURE 2.)
IMPORTANT NOTE: Follow all local electrical and building
codes when wiring your device and consult an electrician.
Mirror
white
green
black
FIGURE 2
D
E
4
FIGURE 1
D
22-3/4"
Vertical mount
D
C
B
E
1/2"
neutral
ground
live
www.homewerksww.com
House
white
green
black