Rydeen CM-D700 Guia De Inicio Rapido

Vie w Ca me r a
Owner's Manual
DUAL SIDE CAM
Model:C M-D700
Universal Dual Side Camera Kit
Specification:
Colored Video Out: 1.0Vp-p 75(ohm) load
170°
< 0.3Lux
Mirror/Standard(Selectable)
Side View Assist Line Image
Product Features:
1.High Quality C OS lmage Sensor for High Resolution & Night Time Visibility. M
2.Side View Assist Line ON / OFF Selectable. Mirror/Standard Image Selectable.
3. A pair of Mini cameras connected with a special control cable (Y- cable).
4.Automatic Sensitivity Compensation.
5.Water Resistant with IP67-IP68 Standard.
Precautious:
Remove Protective lens covering prior to use.
Be cautious when mounting camera and wiring near fuel tank.
System is designed for +12 volt DC systems only.
RM(SV200)客户专用说明书V2.0-BY02E291-0
规格：445.5*210MM ，120G双胶纸，双面黑色印刷，成品三折
English-1
Electrical Connection:
D ua l S id e
DVD Screen Control Cable(Blue)
GND (Black)
Make Solid Connection
To Chassis Ground
1) Locate a flat surface on the bottom edge part of the side mirror. (See Image 1)
2) Remove the mirror.
3) Find an open area to feed the wire through the hole.
4) Make sure there is enough wire and no wire loop inside the mirror that can get caught by the motor for moving a mirror.
5) Establish connections (ACC, Turn signal, Video RCA and Ground).
6) Power the camera ON and check the monitor for the picture.
7) While looking at the monitor, angle the camera. Recommended angle is 45-60 Degrees from the vehicle (See Image 2).
8) After adjusting, stick the camera under the side mirror.
9) After sticking the camera under the side camera, installer can adjust the actual camera using the supplied "U-Shape" tool.
(See Image 3 & 4).
10) Make sure the guidelines is evenly running down on the side of the car matching ( See Image 5 ).
11) Installer should measure what each line represents. Ex: Distance between ORANGE line and RED line.
12) Make sure to check all the functions first before assembling the side mirror and panels back.
*Gridlines can be disabled if it does not match the vehicle's specs.
Image(1)
Angle Adjuster
(Tool)
Image(3)
Image(5)
Technical Support Contact Info:
If you have other questions about RYDEEN Camera products, please contact your retailer or Technical Support:
Telephone: 1-877-777-8811(within USA only)
Email: tech1@rydeenmobile.com
Web address: www.rydeenmobile.com
For more detail instructions please visit: www.rydeenmobile.com/camerahelp
OR
Right Camera
Turn Right Signal Control Cable (Orange)
Turn Right Signal Control Cable (Orange)
Side View Assist Line
ON/OFF Selectable
Voltage Regulator
White
3.3V Output
3.3V Input
Black
Turn Left Signal Control Cable (Pink) Side View Assist Line
ON/OFF Selectable
ACC (Red)
OR
Turn Left Signal Control Cable (Pink)
Left Camera
Assist Line for Right Side View
Left Side View
Image(2)
Angle Adjuster
(Tool)
Image(4)
Angle Adjuster Angle Adjuster
(Tool) (Tool)
Image(6)
English-2
F a c e C a mé r a
Manuel d'Utilisateur
DUAL SIDE CAM
Sp cifications é :
agonal 170°
< 0.3Lux
IIIumination Minimale
Ima Mirroir/Standard(Selectionnable)
Image de Ligne Guide Latérale
Caract ristiques du Produit é :
1.Capteur d'Image CMOS de Haute Qualité pour Haute Résolution et Vision Nocturne.
2.Sélection Avec / Sans Ligne Guide Latérale. Sélection d'Image / Standard.
3. Câble de contrôle (câble Y) pour caméra de vue de côté double inclus.
4.Compensation de Sensibilité Automatique.
5.Résistant à l'Eau avec norme IP67-IP68.
Mises en Garde:
Enlever le protecteur de lentilles avant l'utilisation.
Prenez garde lorsque vous installez la caméra et/ou le filage près du réservoir à essence.
Système conçu pour systèmes +12 volts DC uniquement.
French-1
Vue D o uble
Model:CM-D700
Caméra de double Vision Latérale Universelle