Cleaning And Maintenance; Troubleshooting - NORAUTO 2270881 Manual De Instrucciones

The desired cooling capacity is selected with the cooling capacity control:
EN
• To increase the cooling capacity, turn the cooling capacity control dial clockwise.
For the maximum cooling capacity turn the cooling capacity control clockwise all the
way to the stop (MAX position).
• To decrease the cooling capacity, turn the cooling capacity control counter clockwise.
For the minimum cooling capacity turn the cooling capacity control counter clockwise
all the way to the stop (MIN position).
IMPORTANT: When the cooler is connected to the DC socket, it cools at the maximum setting
and the cooling cannot be adjusted.

CLEANING AND MAINTENANCE

• WARNING: Always disconnect the device from the power supply before cleaning or
maintenance.
• Never immerse the unit in water or other liquids.
• Wipe interior and exterior with a damp cloth and neutral cleanser.
• Do not use abrasive cleaning agents or hard objects during cleaning as these can damage
the product.
• Keep the ventilation slots free of any dust and dirt, so that heat can be released and the
device is not damaged.
• Carefully wind up the power cord and store it in the power cord compartment.
• Ensure the inside is fully dry before storing when not in use.
• When not in use the cooler's lid shall be left ajar to prevent mould growth.
• Store the appliance in a cool, dry place, protected from moisture and direct sunlight.

TROUBLESHOOTING

Problem
The device is not working
(plug is inserted).
When operating from the
DC socket: The ignition is
on and the cooler is not
working.
30
Possible cause
There is no voltage flowing in
the DC socket in your vehicle.
No voltage present in the AC
voltage socket.
The inner fan or the cooling
element is defective.
The fuse of the DC plug is dirty.
This results in poor electrical
contact.
The fuse of the DC plug has
blown.
The vehicle fuse has blown.
Suggested remedy
The ignition must be
switched on in most vehicles
to apply current to the DC
socket.
Try using another plug
socket.
This can only be repaired by
an authorised repair centre.
If the plug of your cooler
becomes very warm in the
DC socket fitting, either
the fitting must be cleaned
or the plug has not been
assembled correctly.
Replace the fuse of the DC
plug with one of the same
rating (8 A).
Replace the vehicle's DC
socket fuse (usually 15 A).
Please refer to the operating
manual of your vehicle.