What To Do If - JPL CRISTAL PROFI i60 Manual De Instrucciones

connections clip properly into place (1). Return the filter to its original place in the aquarium and install any accessories as
previously.
Plug the filter to the power supply.
Regulate the flow to the desired rate.

What to do if...?

The pump head or module cannot be correctly fitted
Cause
Dirt (sand) in snap fastenings
Filter does not run or no water flows out
Cause
No power supplied
Impeller missing or blocked by gravel, wormgear casing or
rotor faulty
Filter capacity greatly reduced
Cause
Flow regulator set incorrectly
Suction slit blocked
Filter material heavily soiled
22
Solution
Clean snap fastenings.
Solution
Plug in the mains plug, making sure to check the socket for
the right voltage
Clean impeller casing, fit intact impeller
Solution
Check position of regulator and correct
Clean suction slit
Clean filter material