Descargar Imprimir esta página

Prilux VOLTORE Serie Instrucciones De Montaje página 3

Publicidad

VOLTORE
Ø120
DR
DI
DRIVER
DRIVER
230
INCLUIDO
INTEGRADO
WARNING
BEFORE STARTING THE INSTALLATION OF THIS PRO-
DUCT, PLEASE READ CAREFULLY THE FOLLOWING INS-
TRUCTIONS AND KEEP THERE IN A SAFE PLACE.
THE INSTALLATION MUST BE CARRIED OUT BY QUALI-
FIED STAFF.
IMPROPER HANDLING OF COMPONENTS OR THE OWN FIXTURE
ITSELF MAY DAMAGE THE PROPER OPERATION OF THIS PRODUCT,
CONSEQUENTIALLY THE MANUFACTURER'S WARRANTY WILL BE
VOID.
FAILURES CAUSED BY INSTALLATIONS OUTSIDE OF WHAT
THE REBT 2002 INDICATES, EXEMPT THE VALIDITY OF THE
WARRANTY ON DAMAGED PRODUCTS.
IT IS OF OBLIGED COMPLIANCE WITH INTERIOR INSTALLATIONS
THE APPLICATION OF ARTICLE 16, POINT 3 OF THE REBT.
PRECAUTIONS
• Read this manual before installing the product. If in doubt,
consult qualified personnel.
• If the product is damaged, replace it immediately with a
new one.
• Disconnect the power before installing the product.
• Keep the product out of the reach of young children.
• Do not handle the product while it is in operation and let
it cool before touching it with your hands.
• Do not install the product where there are heat sources or
moisture concentrations.
• Not valid for use in bathrooms.
• Only for interior use.
• Non-replaceable light source.
Ø120
170
MODELO I
[GRÁFICOS: Unidades en mm/ GRAPHICS: Units in mm/GRAPHIQUES: Unités en mm/GRÁFICOS: Unidades em mm]
MODELO II
OBSERVE
PRECAUTIONS
HANDLING
SENSITIVE COMPONENTS (LED).
ASSEMBLY INSTRUCTIONS
NOTE: THIS PRODUCT MUST BE INSTALLED IN A THREE-PHASE
230V 50HZ TRACK, FOR THE INSTALLATION OF THE ELECTRIFIED
TRACK FOLLOW THE INSTALLATION MANUAL OF THAT LANE.
1. Disconnect the power before installing the product.
2. Insert the product connector into the electrified track,
taking into account that it must be powered by phase
and neutral at 230V 50Hz.
3. Secure the product on the electrified track so that it is
securely fastened.
4. Set the project to the area to be illuminated.
5. Restore the current.
REPLACEMENT OF THE LAMP
This luminaire works with a single LED chip, which is not
replaceable.
165
Ø94
235
FOR
ELECTROSTATIC

Publicidad

loading