Technical Data - aldente LUXOMAT D Manual De Instrucciones

2.2 Intended use
This light curing unit is exclusively designed and constructed for curing polymerizing dental materials: You may choose curing times of
5 or 10 minutes or even a continuous operating time.
2.3 Safety instructions
• When using UVA-/UV-lamps, the regulatory recommendations for application as well as labour protection regulations
have to be considered.
• The elements you wish to polymerize should always be inserted when the fluorescent lamps are off.
• After about 1,000 operating hours, the lamps lose their luminous intensity, therefore the polymerizing times have to be increased. Kindly
take this into consideration for your time selection or exchange the lamps.
Attention!! Disconnect mains beforehand!!
• For disposal the valid legal regulations for electronic waste have to be observed.
3. INCOMING CONTROL
Please check the unit and accessories immediately after receipt for probable transport damages and defects. Warranty claims
can only be enforced if the vendor or shipper is informed immediately. A damage report has to be elaborated immediately.
4.

TECHNICAL DATA

Mains supply
Max. power consumption
Fuse of unit
Spectral range
Dimensions
Polymerization chamber
Number of lamps
5. INSTALLATION
• Place the included UVA and ultraviolet lamps into the socket in the curing chamber of the unit (see below).
# 9 W / 78 or # BL 350
• The unit has to be put onto a stable horizontal basis in a dry surrounding.
• When mounting the device keep at least a distance of 30 cm to easily inflammable materials like paper, etc.
• The packaging can be disposed of with domestic waste.
6. OPERATING
6.1 Connect power cord
6.2 Place workpiece to be processed onto the charging drawer.
6.3 Turn on the unit by pressing the power switch at the back side of the unit.
6.4 Operating elements
6.5 Choose curing time by pressing button „Time".
6.6 Start the unit by pressing button „Start/Stopp". When choosing curing time of 5 or 10 minutes, the unit shuts off automatically.
6.7 By re-pressing the button „Start/Stopp" the curing time can be interrupted at any time.
6.8 The curing time chosen at last, is automatically saved.
4
230 V AC 50 HZ ± 10 %
appr. 36 W
mT 500 mA
350 – 500 nm
245x250x170 mm (WxDxH)
200x135x120 mm (WxDxH)
2 pcs. UVA-lamps (213-920-023) and 2 pcs. ultraviolet lamps (213-920-022)
# 9W / 71 (ultraviolet)
1 Button Start / Stopp
2 Button Time
3 LED curing time of
4 LED curing time of
5 LED curing time
# 9 W / 71 (ultraviolet)
# 9 W / 78 or # BL 350
5 minutes
10 minutes
constantly