Assembly Instructions; Care And Cleaning; Case; Rear Vent Filter - GE ADTK15 Manual Del Propietário

Assembly instructions.

1. Slide the
base halves
together
and press
them firmly
into place.
2. Align the power cord
channel on the base
with the power cord
on the unit.
Care and cleaning of the portable room heater.
Turn the portable heater off, allow it to cool completely and then unplug it before cleaning.

Case

To clean the case:
Wipe the outer surface of the heater with a clean,
soft, dry cloth. Do not use a wet cloth for cleaning.
Do not use bleach, chemicals or abrasives since they
might damage the paint.

Rear Vent Filter

Clean the rear vent filter when visibly dirty or dusty.
Use a vacuum cleaner, with a nozzle attachment,
to remove dust and dirt by passing it over the grille
surface.

Remote Control

To replace the battery:
1. Slide the battery cover open on the back
of the remote control.
2. Remove the old batteries.
3. Insert new batteries, placing them so
their polarities (+ and –) match the markings
in the battery compartment.
4. Slide the cover back into position.
Extended Storage
Save and use the original box and packaging when
storing the heater for extended periods of time. Store
the heater in a cool, dry place.
Underside of base shown.
Topside of base shown with power
cord routed in channel.
(on some models)
(on some models)
3. Attach
the base
to the unit,
using the
four screws
supplied.
WARNING:
Never immerse the heater
in water.
NOTE: The rear vent filter is not removable and should
only be cleaned with a vacuum cleaner.
NOTE: Replace with the same size batteries as
removed. Remove the batteries from the remote
control if the system is not going to be used for
a long time.
CAUTION:
Do not mix old and new
batteries; replace batteries in sets. Discard old
batteries safely. Keep batteries out of reach of
children.
ge.com
5