Installation Instructions - Allen + Roth BROOKES 21-B45WDCP-AR Manual Del Usuario

INSTALLATION INSTRUCTIONS

1. Shut off the water at the supply valves under the sink or at the
main water supply. Disconnect the supply lines. Remove the
existing faucet from the sink.
Clean and dry the surface area where the new faucet will
be mounted.
2. Insert the mounting shank (2.1) on the spout (A) through the
center mounting hole in the sink (2.2). Secure the spout (A) using
the rubber washer (CC), metal washer (AA), and mounting nut
(BB). Hand tighten the mounting nut (BB) onto the end of the
shank (2.1). Then attach the middle connector (2.3) on the
hose (E) to the shank (2.1).
Hardware Used
AA Metal Washer
BB Mounting Nut
CC Rubber Washer
3. Slide the right handle assembly (B) through the hole in the
sink to the right of the spout (A). Make sure the longer tube is
positioned away from the spout (A). Slide the metal washer (EE)
onto the shank (3.1) on the right handle assembly (B) and then
hand tighten the locking nut (DD) onto the end of the shank.
Secure the locking nut (DD) into position by tightening the
screws (3.2) using a Phillips screwdriver. Repeat these steps to
install the left handle assembly (C).
Hardware Used
DD Locking Nut
EE Metal Washer
4. Push the quick-connect assembly (4.1) on each end of the
hose (E) firmly upward onto the handle tube (4.2) until it snaps
onto the handle tube tab (4.3). Pull down gently to ensure the
connection is secure.
If it is necessary to disconnect the quick-connect assembly (4.1)
from the handle tube (4.2), squeeze the tabs on the quick-
connect assembly (4.1) and pull down to remove from the
handle tube (4.2).
x 1
x 1
x 1
x 2
x 2
4
1
2
CC
AA
BB
2.3
3
C
3.1
A
3.2
E
4
4.2
4.1
4.3
A
2.1
2.2
E
B
EE
DD
A
E