nurse CABRIO Instrucciones página 8

CABRIO
INSTRUCTIONS FOR ASSEMBLY AND USE
TO OPEN THE WALKER
1
Open the walker by raising the tray to the highest position. (1)
The secondary lock will engage automatically. Push the primary lock to a closed position (8.b) to
secure the mechanism.
TO ATTACH THE REAR WHEELS
2
Slide the metal axle through the centre of the rear wheel. (2)
3
Slot the metal axle up and into the moulded socket located on the underside of the walker. (3.1)
Then gently bend back the flexible housing plate (3.2) Place the axle through the hole in the plate
(3.3) and allow to retract to retain the wheel.
4
The assembled wheel should look like this. (4)
TO ATTACH THE FRONT WHEELS
5
Insert the castor wheel into the moulded socket in the direction indicated by the arrow. Then push
up firmly until it clicks into place and attaches. (5.a)
Upper wheels: Fit the 4 upper wheels horizontally in the slot found in the centre of the wheel.
Press until you hear the safety click. (5.b)
FITTING THE SEAT UNIT
6
Insert seat-chip into top tray's trough. (6.a)
Front of the seat
7
Repeat the procedure of locking the plastic pins into the keyholes.
Warning! Always ensure the seat unit is correctly fitted prior to use. (6.b)
ATTACHING THE TOY TRAY
8
Insert two AA 1.5 Volt batteries into the battery compartment. (7.a)
· Attention! The batteries must only be changed by an adult.
· Keep batteries away from children at all times.
· Use only the recommended batteries.
· Insert the batteries correctly (noting +/- markings).
· Do not mix different types of batteries or new and old batteries.
· Do not use rechargeable batteries.
This electronic device must be recycled according to the directive 2002/96/CE.
All electrical or electronic apparatus must be correctly disposed of in collection points designated by local
authorities.
FIXING THE TOY TRAY
9
Unfold the walker and place the toy tray into position. Push the locking keys located on the
underside of the walker tray up and turn around to secure the toy tray to the walker (7.b)
TO ADJUST THE HEIGHT OF THE WALKER
10
The locking mechanism is located on the underside of the top tray. Push the primary lock forward.
Push the secondary lock in and select the desired height for the walker and then release the
secondary lock. Pull the primary lock back towards you to secure the walker into the new height.
To close the walker do not allow the mechanism to close into a notch but to slide shut together
in a downward motion. (8.a, 8.b)
MAINTENANCE
Do not expose the cover to sunlight for long periods.
Wash the plastic parts with warm water and soap and carefully dry all the components after.
· Do not recharge non- rechargeable batteries.
· Remove used batteries.
· Do not short circuit the terminals.
· Keep packaging outside the reach of children.
· Keep these instructions for future reference.
7