Chapin 19049 Manual De Instrucciones

WARNING
WARNING: Improper use or failure to follow instructions can result in explosive failure causing serious
eye or other injury. For safe use of this product you must read and follow all instructions. Do not leave a pres-
surized sprayer in the hot sun. Heat can cause pressure build-up resulting in possible explosion. Do not store or
leave solution in tank after use. Always wear goggles, gloves, long sleeve shirt, long pants and full foot protec-
tion when spraying. Never use any tool to remove pump if there is pressure in sprayer. Never stand with face or
body over top of tank when pumping or loosening pump to prevent ejecting pump assembly and/or solution
from striking and injuring you. Never pressurize sprayer by any means other than the original pump. Do not
attempt to modify this sprayer. Replace parts only with manufacturer's original parts. Never spray flammable,
caustic, acidic, chlorine, bleach or other corrosive solutions or heat, pressure, or gas producing chemicals.
Always read and follow chemical manufacturer's instructions before use with this sprayer as some chemi-
cals may be hazardous when used with this sprayer.
Congratulations!
You have just purchased a quality Chapin product.
Register Your Sprayer Online @ www.chapinmfg.com
Questions? Do Not Return To Store.
Call us @ 1-800-950-4458 or www.chapinmfg.com
¡Felicitaciones!
Usted acaba de adquirir un producto de calidad Chapin.
Registre su pulverizador en línea en www.chapinmfg.com
¿Preguntas? No regrese a la tienda;
llámenos al 1-800-950-4458 o visite www.chapinmfg.com
Félicitations!
Vous avez acheté un produit de qualité Chapin.
Enregistrez dès que possible votre pulvérisateur en
ligne à l'adresse suivante: www.chapinmfg.com
Questions ? Ne retournez pas au magasin.
Appelez-nous 1-800-950-4458 ou
visitez le www.chapinmfg.com
19049
Parts, Piezas, Pièces
6-5943 6-5797
Nozzle 1.0 GPM Nozzle .5GPM
Tobera Tobera
Buse Buse
6-6092
Hose Black
Manguera para trabajos pesados Negro
Tuyau pour service intense Noir
6-7705
Extension wand, Vara de extensión, Rallonge
6-5373
Holster
Funda
Étui
Note: Your particular sprayer may not include all parts pictured above.
Nota: Es posible que este pulverizador en particular no incluya todas las partes que se ilustran arriba.
Remarque : Votre pulvérisateur particulier pourrait ne pas inclure toutes les pièces illustrées plus haut.
Repair Parts Kit Gaskets and Seals (not included),
Juego de piezas de reparación, empaquetaduras y juntas (no incluido)
Kit de pièces de réparation, joints et garniture d'étanchéité (non inclus) 6-4646
1. Hose to Tank
1A
2. Nozzle
Sk-1154-1
2A
Attach nozzle to shut-off handle or extension wand.
3. Pre-Use Check
1) Do: Check tightness of hose nut to be sure hose is securely attached to the tank outlet.
2) Do: Inspect hose for deterioration, cracks, softness, or brittleness. If any of these conditions are found, replace
hose before using. Replace with original manufacturer's parts only.
3) Do: Remove pump (see Filling, Pressurizing and Spraying Instructions), inspect interior and exterior of tank for
signs of deterioration of body and bottom. Any sign of deterioration indicates possible tank weakening and could
result in explosive bursting under pressure. If any of these signs are found, discard tank immediately and replace.
Do not attempt to patch leaks, etc., as this could result in serious injury.
4) Do: Follow Filling, Pressurizing and Spraying Instructions, except use water only (Pump plunger 10-20 strokes and
inspect for leaks).
5) Do: Direct shut-off away from you and open to make sure discharge is not clogged.
6) Do: If unit passes this test, release pressure (see Pressure Releasing Instructions), empty tank, and proceed with
Filling, Pressurizing and Spraying Instructions.
7) Do: Inspect all metal parts including the wand, nozzle and fittings for rust, corrosion and pitting. If any of these
19069
conditions are found, replace affected part with original manufacturer's part before using.
4. Filling
1) Do: Turn pump handle counterclockwise and remove pump
2) Do: Prepare spray solution following all directions and safety warnings on chemical label.
3) Do: Fill tank to no more than the proper gallon marker. Do NOT: overfill to accommodate
pump.
6-5380
4) Do: Check pump to make sure that no grass or dirt is stuck to barrel. Replace pump in tank
Shut-off handle
Mango de cierre and tighten securely.
Poignée du robinet
5. Pressurizing and Spraying
5A
TO LOCK HANDLE: Push handle down to depress coil
spring and turn handle 1/4 turn clockwise, then allow handle
to raise into lock position.
015644-19 (A) R0318
Attach the hose by screwing the swivel
nut clockwise and tightening to 37 in.
lbs. Refer to Pre-use check before using.
2B
5B
Lock
Position
5. Pressurizing and Spraying, continued
5C
TO LOCK PUMP: Place pump prongs down into
slots in funnel, turn clamp clockwise to furthest posi-
tion under bottom slot, then turn handle clockwise
until tightly locked and sealed in place.
5D
TO UNLOCK PUMP: Turn handle counterclockwise until
3-prong clamp is loose. Then rotate clamp counterclockwise to stop
and lift out.
5E
TO RELEASE HANDLE: Push down to depress coil spring and
turn handle counterclockwise 1/4 turn, then lift handle.
5F
Pump until you feel resistance.
6. Fatigue-Free Spraying
For constant spraying, push down on shut-off
handle and move locking mechanism away from
you. To release, squeeze handle and move the lock-
ing mechanism back towards you.
7. To Release Pressure
1 Do: With pump facing away, turn locked handle counterclockwise until air begins to
escape. Stop turning handle when you hear air escaping.
2) Do: Stay away from the sprayer until all air has escaped.
8. Care, Storage and Maintenance
1) Do: Rinse tank thoroughly with water only, empty, refill with water. Follow Filling, Pressurizing and
Spraying Instructions, except pump unit only 8-10 strokes. Be sure that the wand and nozzle are
thoroughly rinsed with water after each use.
2) Do: Open shut-off and allow water to run through discharge assembly.
3) Do: Release pressure (Follow Pressure Release Instructions), remove pump and empty sprayer.
4) Do: Store sprayer tank upside down, with pump removed, in a warm dry location.
5) Do: Periodically oil pump by dropping 10-12 drops of light oil down pump rod through opening in cover.
6A